开云体育

VE7PS via groups.io writes: That's the problem with MS-4s. They accrete in corners and under tables, out of visible sight lines. It wasn't until a couple of months ago I discovered I had four of the

Lyndon... Yeah I thought about that MS-4 and if we had met at a fleamarket I probably WOULD have picked it up...but shipping adds silly cost now and thought better of it. I'll take a look next weekend

Lyndon....."Just tryin' to hep folks is all". I built a stash of many different C-J connectors used in Drake gear about 25 years ago on my visits to a customer in Regina. B & E Electronics is still

Lyndon VE7TFX writes: As a consolation prize, you could buy the MS-4 I have listed on the same site. I want that thing out of here! I need the space back ... --lyndon

VE7PS via groups.io writes: Stop absconding with my connectors! (I already mailed him and beat you to it! :-) --lyndon

I have no connection with the seller, other than I used to live in Elliot Lake, ON 40 years ago, but this price looks pretty good to me. Caveat Emptor! 73 Peter VE7PS ---------- Forwarded message

Those voltages will inly read correctly if the PLL loop is closed. Do you have enough extenders to put the radio into operating condition? The way you have it operating, the output at the test point

Hi Rob; You wrote, " My MIX-4 has a J309 FET properly coupled to the 5695 kHz IF tuned circuit, and separate ports on the NE602 Gilbert Cell mixer for the IF and the LO injections" Have you given

Hi Gary, I did the ground on RFC505 and no change except that the voltage goes very low of course going through a 100K resistor. The frequency counter shows 1.3 MHz on the output of the VCO when it is

Thanks Stan. So yours is 69 units newer than mine, and has the standard board. I wonder how I ended up with this one? Hopefully a few more data points will come in and help settle this (whether it's a

One of my rules is to never leave vintage gear running unattended, even for "just a minute". "Jay W6CJ via groups.io" <lastradioman@...> wrote: -- 73 -Jim NU0C

Stan, You have some great ideas! Happy New Year, Evan, K9SQG

Hi Evan, Happy New Year to you and everyone on the group! Maybe my old post to the group will be useful /g/DRAKE-RADIO/message/33242 Both parts are still available. 73 Stan KM4HQE

Sorry if my keying logic was inverted. The open key would sometimes close long enough to produce a dit or dah, or long enough to slag my T4XC finals (note to self: if leaving the room, turn stuff

I have probably seen maybe 3 tubes that have failed the gas test on a tube tester. The remainder have taken me on various journeys through some really interesting territory. The one that really opened

Hi Lyndon, Mine is a later S/N, 1120.? Here's a no so up close pic of the board in mine. 73 Stan KM4HQE

Great sources. TNX. mgilger_at_charter.net_lastradioman@...> wrote:

Same here. Garry said it was gassy tubes, I didn't believe him but tried new tubes anyway. Fixed it. The amount of gas is so slight it doesn't show up on most tube tester gas tests. My TV-7

YES, even my 13 tube R-4A had fast AVC with a gassey tube! (only until Garey told me I had a gassey tube!). But, the best tubes in an R-4B will still give the too fast AVC. You can tell if an R-4B is

You have my sympathy with your move. My least favorite thing is moving. Done it too often in the past. Right up there with surgery but at least with surgery someone else does it for you. I found the