开云体育

The Twins are all interchangeable — except for the R-4, which uses a 6AU6 mounted on the chassis. Of course, there will be different implementations of dials amongst the three major types but you

How interchangeable are the PTOs? For example R-4B FET PTO with an R-4C PTO?? ? FET PTO with any other FET PTO? Thanks

Group, My twins came back from being worked on by Ron, WB4HFN. While on a HW-16 budget 50 years ago, I coveted these rigs and thought it would be cool to try them after a slight delay. Had my first

The new blower moves over twice the air of the factory blower through the same sk406 chimney. I did the direct comparison using a hand held anemometer... held at the same location and distance above

Thank you, Bob NZ5A

I think it is ok as others have made trades here. If anyone objects I will move to another venue. Vince would you like to text me at 423-368-3982 or call. Thanks again John

Okay at the risk of getting in trouble with the forum moderator and members what is the protocol for going to this transaction I don’t want to bother them or get in any hot water. I have tested it

I will look for the box, give it a quick test and send you a few pics so that you are sure of what is offered. V Sent: Monday, December 16, 2024 2:02 PM To: [email protected] Subject: Re:

Hi Vince. I would like to buy it if it is in good condition as I have an L4 rf deck without a blower. Is $40 plus shipping interesting? Thanks 73 John

Robert Logan via groups.io writes: And therein lies your problem :-) It's 'bydpete'. --lyndon

I am late to this thread apparently there is discussion about L4B and similar blower wheels slash assemblies I have an original L4B blower complete I believe the blower wheel is an excellent or

Just replace it with a gold plated RCA connector.

Whoops, misspoke. The blower wheel is no longer produced by Torrington but Mark found a very close replacement. He may not be converting the wheels at this time but I just wanted to get an update on

Correct, I was trying to get in contact with Mark Huber NO8J to see if he could provide where he got the wheels.? He had stated that it was a manufactured by Torrington and was available. Anyone have

bydpete. - Jerry, KF6VB

Put in “byrdpete” in eBay Search. No cable store. Can you help where to find? Thanks, Bob

Good-O. I have one T-4XB that has caused me to pull hair out! Everything works except for the carrier oscillator. I can't find the culprit and I have rebuilt the oscillator after checking all

This discussion surfaces every once in a while and IIRC, the whole cleaning issue comes down to polar vs non-polar solvents. The two aren't miscible (think of oil & water and you're there). IPA,

Steve, good point mentioning 70 mA. Most folks see 0.1A and stop reading the manual. Have had many many Drakes, re-reading the manuals again, LOL Frank Krozel Life Member, ARRL (630)

Hi, Paul, Does this tx have a 12.6 MHz crystal in one of the AUX XTAL sockets? Forgive me if I'm asking the obvious. The 2.7 sounds like the right value, though the schematic shows a 3.3 there (later