开云体育

The 7075 is a ceramic element mic. Ceramic and crystal elements measure open circuit for DC. They look like capacitors. Your mic may be fine. -- Richard Knoppow Los Angeles WB6KBL SKCC 19998

I have a 7075; tried to get a resistance measurement that was not the PTT closure and every combination was open circuit. Don't have a schematic so I was fumbling in the dark. -- Craig/W8CS

It sounds like someone may have added a filter to the mic. Can you tell if the transformer is open? Is is actually a choke?

That sounds like a legit mod. The D-104 element has very high output and does not need amplification for most rigs but can benefit from a very high load impedance. -- Richard Knoppow Los Angeles

This came with my first TR7, which I bought in 2019 from a ham. The mic worked fine until today. It’s still a head-scratcher… Steve Wedge, W1ES Time flies like an arrow. Fruit flies like a banana.

I have a D-104 that I added circuitry to. A JFET source follower. No gain, but it presents an extremely high impedance to the mike element. Always gets me good reports. - Jerry, KF6VB

I bought the Drake mic with bad mic element. Had an extra Kenwood MC-50 laying around and put that element inside and get great audio reports. Good luck and 73. Tony N5DIM

Sounds like something a CBer might do to get more audio grunt. - Jerry, KF6VB

It is looking like I’ll need to do that. The current element fits but there are series capacitors and that tiny transformer. These components seem to be good (capacitors are dead-on). I was shocked

I put the Heil element in mine. Works great now. Larry - KB9VY Sent from [Proton Mail](https://proton.me/mail/home) for iOS

Hi, gang! I went on to the 7238 Drake Pre-net this afternoon and strange things were happening. I heard some noise in the speaker when the PTT was pressed and WB0IQK said that I sounded excessively

We had 35 check-ins to our net today on 40 meters. More information on the net can be found at Ron's web site at www.wb4hfn.com . The radio's used on the net today were: 8 TWINS 2 TR3 9 TR4(x) 4 TR5 6

Thanks Jim Just need to see if I can get scope leads into the housing to check out the CAL pin diodes. Kind Regards Mike G3ZCC

Hi Mike: Ok good point - good thing Heather didn't see my e-mail! She is sitting beside me as I type this! After 48-1/2 years that's not about to change on my watch. Let's put it this way...Drake rigs

Peter, to clarify, Get married or selling the drakes? Mike, WB8VGE

Hi Gary: Interesting! I only ever had one brand new 4-line...a C-line.....purchased at the Hamburg, NY hamfest from AES in the fall of 1974. I sold it two years later after getting married and moving

I never had a brand new 4 Line but the manual says you need to "snap" in the supplied press fit rubber bumpers. Probably more would have survived if the factory installed them! 73, Gary WB6OGD

I learned something new -- thanks, Peter. My recollection wasn't squaring with reality. Although I have seen some rigs with the AC-4 bumpers installed on them, I now reemmber the press-in bumpers. I

Correct. Steve Wedge, W1ES Time flies like an arrow. Fruit flies like a banana. Sent with [Proton Mail](https://proton.me/mail/home) secure email.

The lower part of the shield provides enough shielding without causing overheating. Nothing is missing.Sent from my Galaxy