开云体育

Look for a Mutch UT-2000B (not the A). They go for short money and will load up the proverbial bedspring. 73, Dick, W1KSZ ________________________________ Sent: Sunday, March 21, 2021 9:16 AM To:

We have a huge hamfest coming up this next Saturday in Sevierville that I'm going to keep an eye out there and see what I can find. Thanks everyone.

Interesting. I don't recall having seen this. Fish paper maybe? 73 -Jim NU0C "Gary Follett" <xntrick1948@...> wrote:

I've been looking at the MN-2700 but like said, it doesn't really match, would love to find an MN-2000C which is an MN-2700 in the 4 line colors which are a little harder to find. I do actually have a

I agree ?with Peter. ?In fact, I use my MN-2000 for 40 meter operation but use my MN-2700 for all other ?bands due to ?the wide matching range. ?Once you find the sweet spot for each band,

Joe – W7RKN From: [email protected] [mailto:[email protected]] On Behalf Of VE7PS Subject: Re: [DRAKE-RADIO] MN2000 Billy: Indeed, the MN-2700 might be a better choice for 160m than trying

Did you check that there is an insulting strip loin top of the PTO mechanism? There is a very close fit between the bottom of the DR7 solder and the grounded metal below the DR7 just below the display

Billy: Indeed, the MN-2700 might be a better choice for 160m than trying to convert an MN-2000.? 160M coverage is already built into the 2700. It won't quite match your 4-line for sure.....but

Hi Billy I would think it near impossible to add 160 to the MN 2000. It looks like a high Q circuit and I read somewhere that it performs best when using antennas of near resonance and is tetchy on

It looks like you have an aftermarket LED board from DF4NW. Nice! However that suggests that someone botched the install and gave up on it. The display is strobed. One set of segment drivers drives

I seem to remember seeing a 160 mod a long time ago. Unfortunately, it involved drilling holes. At a minimum, it would involve adding inductance and fixed capacitors whilst using the bandswitch in the

Thanks Steve. Both digit one and two are missing the two segments I think.. You may be right about the soldering, it was a mess so I re did it . Will check again? and also look at the drivers. I am

Put up a 160 antenna and use tuner on 80-10 ! 73s Byron AC9PA

Has anyone ever modded an MN2000 to work on 160? That’s the only thing that has kept me from snatching one up to add to my C-line I have.

The second digit is missing two segments. It looks like a display or driver issue to me (assuming the etches and soldering are okay). I can’t remember if the display drivers are open collector or

Hi Everyone, hope you are safe and well. I have fitted the rebuilt DR7 and the up/down and jumper works just fine. The first two digits seen to be missing the same part of the display which is a

Hello All Looking for a final cage for my T-4Xb I have reworked the Chassis and need the Final Cage Thanks Bob. kQ2Q. Danielsville GA

My apologies, T-4XB not TX4B

Good day! Wondering if anyone has a lead on TX4B and PS to pair with my recently acquired R4B.? I have some AM plate modulated experience, but this would be my first tube final SSB venture. Also, any

Cowan, The next step would be, with no power to radio, use an ohmmeter across the primary of the audio output transformer. If it's good, you should hear a "pop" in the speaker when you touch the