¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Drake T4XC and D-104 wiring


 

Astatic made another model the C-104 with a ceramic element. Very similar except the output is about 10db lower. This is for the element alone. If there is an amplifier the output levels are probably the same. I have not searched for a data sheet on the C-104.
Astatic made ceramic versions of many of their crystal mics and crystal phono pickups. The ceramic has the advantage of not being vulnerable to heat or moisture.

On 2/23/2024 8:51 AM, Jim Shorney wrote:
My "secret" is to do away with the amplifier and replace it with a series 470K resistor. This is actually an old-timer's trick to mellow out the frequency response of the D-104 head. The amplifier is enhanced uselessness for our radios. It will happily drive just about any radio this way and you get rid of a failure point (actually two if you consider potential battery leakage). This works with any T-UGxx stand.
My understanding is that later D-104 heads used a ceramic cartridge. The same fix applies. The D-104 head likes to see a high impedance load, the higher the better.
I have three T-UGxx variants that I have done this to and tested on the air with good reports. And they can be used with VOX.
73
-Jim
NU0C
--
Richard Knoppow
Los Angeles
WB6KBL
SKCC 19998

Join [email protected] to automatically receive all group messages.