Well, maybe not. If you are using a 1,000,000,000 Ohm ( 1G Ohm or 1000 M Ohm) input meter, yes. Otherwise if you use a typical 10M Ohm type meter, you won't get but maybe half the real reading.
Read why here:
https://www.ebay.com/itm/294886705542
Geo
----- Original Message -----
From: Michael C <mtcooper01@...>
To:
[email protected]Sent: Fri, 13 May 2022 15:01:23 -0400 (EDT)
Subject: Re: [CDV700CLUB] Leni conversion #3
ok I got some measurements.??
I am getting 3V to pin 6 of the transformer, per the schematic.?
I am supposed to get 15V at R5 - only getting 5.6V.??
I measure about 400V after the HV Diode and at the probe wire point on the board.??
so voltage falling off somewhere.??
