¿ªÔÆÌåÓý

  1. BITX20
  2. Topics

WSPR Empty Data

Bob Shaw
 

I am using uBITX 1.080 and uBITS?MM 1.081 to add WSPR count and data. In MM I read from uBITX, fill in count and WSPR generated data, Write to uBITX (Write Target/Write/Match Data/OK and disconnect from uBITX.

When I select WSPR Beacon, I get message EMPTY DATA.

I am at a loss as to where the WSPR data is getting lost? Any suggestions welcomed!

de Bob VA7SU
 

If you power cycle the arduino then read it with MM, are the fields still filled in?
Bob Shaw
 

Powering the uBITX down, reconnecting to MM and reading and decoding does not show the WSPR settings as I originally tried to write. I am using Windows 10.
Just what is the Match Data box in MM actually doing or informing me about? No error messages from MM, only EMPTY DATA from 1.08 Raduino?when attempting to set Beacon Mode even after powering Raduino up again.? Bob
 

Did anyone find out how to cure this problem? I am presently having the same with CEC ver 1.1

73 Roger ZL2RX
 

hi

i had the same error
i changed the COUNT to 1 - in the absence of any real documentation I assume that this is a flag for the active message
i.e. you set 2 for message 2 etc

matt 9V1MH
 

The count is to indicate how many different location options you are providing. If just HOME, for example, the count is 1 and you just fill in one field. If you want 4 different location options you fill in all 4 lines in MM and the count would be 4.

=Vic=

1 - 6 of 6