开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. BITX20
  2. Topics

sBitx v3 - No output

 

Modified for US and emits but very little, ie consumption 6 A output below 0.5w measured at output?
 

Cool! I will look into that this morning.


On Tue, Feb 6, 2024, 8:59 AM Steve Beckman <n3sb@...> wrote:
Hi Scotty;

The work-around for this bug is to set the task bar at the top of the screen to auto-hide.

A proposed software fix is on github being reviewed now.

73; Steve, N3SB

 

Well this is odd. In the middle of a cw qso on 20 meters, version 3 sbitx, the power went up to about 35 watts out with no code pulses showing up on external watt meter...just constant carrier. Going to voice section and keying microphone gives constant power out. What died already?


On Tue, Feb 6, 2024, 9:01 AM Scotty R via <Theroadcalls1=[email protected]> wrote:

Cool! I will look into that this morning.


On Tue, Feb 6, 2024, 8:59 AM Steve Beckman <n3sb@...> wrote:
Hi Scotty;

The work-around for this bug is to set the task bar at the top of the screen to auto-hide.

A proposed software fix is on github being reviewed now.

73; Steve, N3SB

 

Hi Scotty - It's possible that nothing died - you may be getting RF feedback.

Can you try testing into a dummy load?

73; Steve, N3SB
 

I did. Same situation.? It almost is as an oscillation such as un neutralized tube finals.? Same issue on other bands now. Later I will reroute wiring to try that out.


On Tue, Feb 6, 2024, 12:34 PM Steve Beckman <n3sb@...> wrote:
Hi Scotty - It's possible that nothing died - you may be getting RF feedback.

Can you try testing into a dummy load?

73; Steve, N3SB

  

I put the received card in the box, set only the code and the grid and tried = no output! help, where are the parameters received on paper? So I tried V 3.0 and nothing, I updated and still nothing
 

An even wacky idea!no power output all modes (0.5W at 6A)
 

This issue still exists. To avoid complications do not change the Raspberry PI Configuration (Localisation) from US to your Country. You will end up without power output in any mode. I had this issue last night. I dit initially my setup to DE German and had no TX output. After I saw Lorenzo's helpful post, i switched the settings back to US English and there it was all fine. Output is correct.
Many Thanks to Lorenzo.
@ HF- Signals, maybe before this issue is solved, give to all new buyers a small note in there delivery.
--
vy73
(DO1LU)
Bernd
 

?

21 - 29 of 29