开云体育

I saw Farhan on his way in to FDIM - he mentioned the possibility of converting a ubitx to work with the sbitx software.? ?Has anyone tried it and what was involved?

73,
Dean
KK4DAS

Thank you Farhan!? I'm going to give it a try.? I have a Pi 3B and Adafruit 7" touch diosplay.? Downloading the sbitx 2 disk image now - see if it works natively on the 3B - else I'll build from source.? And thanks for the offer of the WM8731 codec.? I'm PM you my details.

73,
Dean

Any progress on this??
--
'72

Hi Aaron -

I got the Pi, display, audio board and SI5351 hooked up and the software loaded and working but I put this on the back burner for other projects.? I decided not to use my uBitx V5 for this.? Instead, I have a single conversion QRO SSB rig that I built a few years ago that I am going to use.? I'm going to build the 40Mhz IF and get the receiver working first.? I'll get it working QRP first then think about higher power.

73,
Dean
KK4DAS

Didn't do that however I did do single conversion to 21.4mhz as I had some really?
nice 10 pole 25 and 50khz Peterson filters.? IT was a decent RX and of course the first
conversion was easy F+21.4 and for the second LO it was find the edges to get
the right IF.? ?I used DBM for both the mixers to save time and MMICs for the
RF gain stages.

---
Allison
------------------
Please use the forum, offline and private will go to bit bucket.