¿ªÔÆÌåÓý

a missing capciator C93 or C103 for Bitx40v3


 

I have one small ceramic capcitator in the parts box i was handed by the hm who felt he couldn't complete the kit. But there are 2 locations on the Bitx40v3 board I have.There is another spot by the toroid, by itself, that as far as i can read it, no D15 nor D16 is installed either.

Are the mising ? Or don't need to be installed ?

Thanks,
--
Jim/N4AAB


 

Jim,
From the instructions at
Solder the 0.1uF disc ceramic (marked as 104) between the yellow and violet wires on the tuning pot


 

No need for any of them. The parts are included in the event you want to revert to the analog VFO. The Raduino replaced the need for the additional componets.

v/r
Fred W4JLE

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Jim
Sent: Monday, July 10, 2017 12:57
To: [email protected]
Subject: [BITX20] a missing capciator C93 or C103 for Bitx40v3

I have one small ceramic capcitator in the parts box i was handed by the hm who felt he couldn't complete the kit. But there are 2 locations on the Bitx40v3 board I have.There is another spot by the toroid, by itself, that as far as i can read it, no D15 nor D16 is installed either.

Are the mising ? Or don't need to be installed ?

Thanks,
--
Jim/N4AAB


 

Jim :?

The Bitx40v3 board came preassembled, likely that cap is the the one intended to go between wiper and ground on the tuning pot.?

See details at :?



Note that this figure depicts a 10 turn pot, but you want same setup from Wiper to ground on a regular linear 10 pot.?

cheers

Michael VE3WMB?


 

Okay, don't worry about it then.

I would like some instructions and schematic. I looked through the files section here, but I'm not sure I got the correct ones.

Thanks,
--
Jim/N4AAB


 

Oh, I need the instructions to add a power supply, antenna, etc. to it. The ham that handed it to me had no paper items except for a half page of paper that listed some components.

I don't see a way to edit my previous post or I would have done that instead of making a new one.

--
Jim/N4AAB


lostfrogsrecords