MAX 9814 AGC for the uBitx help required

[email protected] All Messages By This Member #52182 Hello,? I have downloaded the MAX 9814 AGC circuit courtesy of the uBitx site but? note that no polarities are shown for the? 10uF Capacitors C4, & C6. Can anyone help here please? Thank you. John? ZL2BH
Mike Woods All Messages By This Member #52183 开云体育 John The general rule of thumb is to connect the negative end of the capacitor to the circuit that goes to earth (perhaps via a resistor). In the circuit here:?? C2 is positive going through the resistor to the +5v line and negative to ground C6 is positive going to the Output of the MAX9814 module, and negative to the top of the potentiometer via R2 (and then to ground through the lower connection of the pot. Mike ZL1AXG ubitx.net On 17/06/18 7:16 PM, johnelvy via Groups.Io wrote: Hello,? I have downloaded the MAX 9814 AGC circuit courtesy of the uBitx site but? note that no polarities are shown for the? 10uF Capacitors C4, & C6. Can anyone help here please? Thank you. John? ZL2BH -- Mike Woods mhwoods@...

开云体育