开云体育

Hi stranger!
What program are you using to do layout?
I do the silk for the first of the step and repeat only...

de N5LXK? 73? k

Hello Robert,

I'm using the EasyEDA software and have had great luck with them. The last time I mad the "official" component identifiers invisible and added "text" artwork ......that worked but was a pain.

73 Kees K5BCQ?

Hi. Are you meaning this question for Don, ND6T ??
Looking at his page, I see that he uses a small piece of single sided PCB and cuts the "breaks" in the copper by using a knife. It isn't etched. There is a ham who is etching the board, in another thread he is mentioned and you should go there to see how to "order" one. Or perhaps ask how it could be done.?

Found it ......I think you do this at the board order step in the sequence and it's easy. That was difficult to do previously (when I was doing it manually) and Advanced Circuits said they didn't want to do any "step and repeat".....one of the reasons I switched.?

The RXTX Click Eliminator is attached .....I think

73 Kees K5BCQ