开云体育

Does anyone have the pinout/wiring diagram for the "Digital Adapter Board" as sold by

?

Its been a while since I bought the box/boards and now I'm finally getting to them but have lost the paperwork. I tried visiting their site to download it but nothing found. My intention is to add a small USB hub board to the back of the connector (as found on Amazon - 2 for $10) and wire the Radiuno and a CM108 sound interface directly into the box making for a single cable control/audio solution.

?

Thanks!

?

Mark NI2O

At the risk of replying to my own post ....

?

I found this reference in the list archive but the page no longer exists? ...

?

https://ubitx.com/2018/07/28/digital-adapter-board/

?

The Wayback Machine produced this but there's nothing there of worth either ...

?

https://web.archive.org/web/20181013095916/https://ubitx.com/2018/07/28/digital-adapter-board/

Send me an email at vu3sua@...

So I broke out the meter. The pinout is in fact incorrect or rather does not follow the industry standard for USB connectors.? ?It *should* be (with USB header pins on the top/left of the board) from left to right, 1/2/3/4 5V/D-/D+/GND.?

?

Looking at the pin side of the board with the USB connector on the top/left we actually have? 1/2/3/4 GND/5V/D-/D+.?

?

I guess this is not an issue if you are soldering a wire to the pin holes but pre-made header cables will not work. I was trying to avoid soldering wires to this board in favor of the header pins. Luckily I have a stash of pre-wired 4 pin Dupont connectors. Moving the pins around is trivial. I'll just have to make sure I mark the cable correctly as I'll never remember that it's not 1-1 in 5 years time when I service the radio.

?

While I was at it I mapped the DB9. Again, from the left of the header 1/6/2/7/3/8/4/9/5.

?

I hope this helps someone.

?

Mark

Sorry if this is a dumb question, but why do you need this? The ubitx already has cat control and picking off audio is not very difficult. I added a cheap sound card to mine and it does digital modes just fine.

What ubitx do you have? I'm betting you did not make it and that its a Chinese copy from ebay? I have a V5 board and box. Everything has to be wired by hand. CAT control for mine is directly on the Radiuno board buried inside the box. The Digital Adapter Board brings out USB/AF/etc to a set of connectors at the back - once you wire them up.