开云体育

I agree, it would be helpful to have the IP address consistently displayed. Perhaps showing it in the MENU screen instead of solely on the right panel of the main screen would be a better solution.

When I use my zBitx in FT8 mode with AUTO set to ON, the messages related to finalizing of my QSO (RR73/RRR and 73) are not displayed on the screen (at the end of the scrollable list). I have to open

Unfortunately, that doesn't work with my Android smartphone. I can't connect from my smartphone to its hotspot client via mdns. However, if I know the client's IP, I can connect to it giving the IP

The “very little data is being written” only applies to the sbitx application, the rest of the system is writing data constantly to log files. Unless you create a system that can run from a

I have supplemented the pdf file for easier understanding. -- Gyula HA3HZ

Did you happen to increase the IF Value? [email protected]> wrote:

Hi! Update the software again. You may have an update error. Make a new memory card. The procedure is described in the operating instructions. This helped me when I had no output power. HA8LKT Laci

Hi! The noise goes away when you disconnect the screen and use an external monitor. This is my observation. HA8LKT Laci Grant Brown via groups.io <grant.brown73@...> ezt írta

Oh, and even after calling? CQ a bunch of times and calling others sending CQ PSK reporter did not have any reception of my calls, and an inline separate SWR meter showed 3 watts of power going to

Playing around with it a bit tonight - seems that a bit of shielding between the pi and the board may help, especially with some of the noises. I'm getting screen update noise and a periodic crunchy

Oh and yes it's populating with other FT8 calls and CQs

I'm somewhat familiar as I have done FT8 with my sBITX, I updated the radio, it synched up with the time server and set that, viewing the output on another receiver it looked like the carrier wasn't

Been making a few Q’s on 20CW at about 20wpm with TR delay at 500mS. Not too bad.

That's an interesting thought regarding the shutdown process for the ZBitx. Expanding on your idea, it seems quite logical to have a dedicated button displayed on the user interface that initiates the

Perhaps. I have seen issues similar to that with poor neutralization on a tube amplifier, although the bad oscillation was never a higher amplitude than the intended signal in my experience. I

That’s a good theory also!

I think your symptoms point to an instability in the final amplifier or drivers.? The off frequency oscillation shows as higher power and high SWR.? Since it is intermittent I would look for a part

Correct, yet corruption is even less likely if you do an orderly shutdown.? The OP coded a way to do that when you don't have a keyboard, which is supposed to be a major use case for zbitx. It feels

Are you seeing callsigns, etc, and other activity with good signal levels? Or is it that you just can't actually make a contact? Make sure your time is properly synced, as for FT8, it is critical.

Been unable to make any FT8 contacts, I discovered that if I look at the received waterfall on a separate receiver the transmission begins with a normal looking bandwidth for a few seconds ?then