开云体育

At yahoo think they had an option to select the post, direct, condensed, daily, weekly. Don’t see this (yet) at groups.io. Ron – PA3FAT Verzonden: 27 January, 2017 18:04 Aan: [email protected]

Kevin, you can make a "Forums" tab in your gmail interface that will catch all of these bitx40 messages and keep them out of your primary inbox. I just did this myself.

Library for the si5351 here??si5351 library ( https://github.com/etherkit/Si5351Arduino ) Rob

I would add that the rig (main) power needs to be OFF. ?Let USB power the Nano. ?Depending on wiring, you will fry the regulator on the Nano. ? Ask me how I know... (although not on a Raduino

Bob, It's here.?BitX40 Sketch ( https://github.com/afarhan/bitx40 ) I'll find the libraries for you. I'll try and put up simple instructions of how to load the sketch. Rob

The purpose of the group is to share all information (posts) that are run through the BITX group on groups.io. You can create a filter that moves them somewhere else or you can unsubscribe and parse

Dear Rob, THANK YOU!!!!??? I was hoping that software might be the problem.? Your instructions are clear except as where to down load the software I need to reload the Arduino... Thank you Again!

I've seen this quite a few times with Arduino's and LCD.? Usually caused by a voltage spike at switch off or on. This corrupts the Arduino software sketch somehow. They are quite rugged devices and

John Smith, Check the center pin of the tuning pot with a voltmeter to ground as you turn the knob back and forth, make sure the voltage tracks the knob position closely. ?If it does not, unhook the

Gentlemen, ?Posts, posts, posts, are peppering my email every day. I love the BITx radios but I don't need every post to come alive on my email. Editing my preferences doesn't seem to help so I just

Gentlemen, Posts, posts, posts, are peppering my email every day. I love the BITx radios but I don't need every post to come alive on my email. Editing my preferences doesn't seem to help so I just

Hello all, Looked through the archives and see many complex (for me) topics covered, so this one should be simple -- for someone else on this list, that is. Built an earlier, through-the-hole BitX 20

In terms of RFI shielding, wouldn't a metal case be better, or are levels so low that it isn't an issue.

Recently assembled my BITX-40 with DIGITAL READOUT/ VFO and was testing TX & RX...?? Seemed to be working OK. ? ?I turned it ON and OFF after about 1hr and the Digital Display instead of reading

I just assembled my BITX-40 with DIGITAL READOUT/ VFO and was testing TX & RX... All seemed to be working OK, for an hour. I turned it ON and OFF after about 1hr and the Digital Display instead of

I haven't even soldered the first wire?but trying to understand the radio and the Uno has been a fantastic learning experience. I was surprised that I already knew the answer to which wire to ground

I 3-D printed mine from an STL on Thingiverse. Working on printing a box, now... RichKC8MWG

You can also check this site out. Locate a bezel that will fit, select the order link, pay for it and within a few days the bezel will be sent to you. I just ordered a bezel for a 2.8 TFT display. If

I see how you are injecting the audio into the mike jack and understand about the DPDT to use the mike or the key... But, how are you doing the PTT switching?

Excellent! Brilliant! I think this will be a great demo for my students. ?I love the DIP connector to keep wires in correct phase. Thanks