开云体育

To switch from 32-bit to 64-bit you will need: a new uSD card of good quality, 32GB, a USB stick, so that you can transfer copies from one OS to another, later copy the daily variables here. a lot of

I just found the info in the manual that was just released. Barrel connector is 5.5 x 2.1 mm. Battery needs to provide 3 amps.

I see, so you have the v3.0 alpha version in the firmware on your device. Since development is almost complete on the 32-bit version, it is worth switching to the 64-bit Image if you want to use the

... It is worth switching to the 64-bit OS, because the development is happening here. The current Image contains most of the programs needed for radio broadcasting, which you can implement with this

I hope you have updated the raspberry pi too [email protected]> wrote:

Hi Gyula, Thanks for the response. I bought this rig at a tailgate yesterday. The seller seemed like he didn't use it much and was not very helpful. When I click on the icon the software starts fine

Time sync not working - same as reported in issue #4...

Yep, I will flip the version if the early tests find it okay [email protected]> wrote:

OK the hardware version is v3, when you turn it on it says which firmware version. Did you just buy it from the manufacturer? Then I think it might be v3.021 or something similar. If you have a spare

v3

Which version? -- Gyula HA3HZ

I have not familiarised myself with this new one, but a common problem is the barrel jack input......ensure you have the correct centre pin sized jack or you wont get connection.....so easy to get

Good morning all, I have been interested in the SDR rig and finally picked one up yesterday. I looked up the manual, watched a few videos but cannot figure out a few things. #1 when i touch the KBD

Uploaded fine ... but shows up as v1.04

USB-C with PD are a better solution as they are less likely to be producing noise. However, you should note that the power bank has to be big enough to provide 3 A @ 9V.

Hello Ragav, Thank you for preparing the new manual. For document control purposes, PLEASE place a Revision Number such as V1.0 and a DATE, such as March 30, 2025, on each issue and keep that

-- Glen, WB4KTF, Austin, TX

Try this https://github.com/afarhan/zbitxfrontpanel/blob/main/zbitx_front_panel_sw.ino.uf2 [email protected]> wrote:

Couldn't download zbitx_front_panel_sw.ino.uf2 from HFSIGNALS page. Downloaded code from zBitx page.- zbitx_front_panel_sw.ino.uf2 dated 3/30 9:15 AM. Xfer to zBitx - no response (stays on gray

Yes, drive is set to 100 and I am using the native application. The voltage coming off the barrel connector of the included battery holder is 7.56(display shows +7.4v) with 2 brand new fully charged