开云体育

The old phonestack/BITX20 URL is no longer valid. I have changed that reference which was at the bottom of each email to show "https://www.vu2ese.com/" which is where the old web site has been moved

here the discussion with Evan [email protected] | A strange thing about calibration!! ( /g/BITX20/topic/77865215#83311 )

hello, *I think I have found, but I will almost give my tongue to the cat!* If I load the Ubitx version of KD8CEC for model 234 with Smeter or not, *I have no more problems.* Whether I take the one

I have the HS code for toroids. Thanks to everyone for replying back . The HS code is 85051110 for Ferrite cores . Best regards

Christian, For my tests the screen Nextion is completly deconnected. i know it can make some noise but is't? completly different in my case. I have gained experience on this type of assembly The

Thank you for the kind reply and data. Greatly appreciated. There are several bom's for the bitx20. So i am trying to make sure i use the right one to order parts for the rest of the rig. Thank you!!!

Hallo, do you use a Nextion Display? 73, Chris!

Zvika, What value did you use for the DC block capacitors? Thanks, Stephen, KO4CVU

Attaching the required files

Can you post us the schematic? The thing to do would be to draw them out in ltspice and measure it for yourself. I am sure someone here can set it up for you

Newbie here.....i bought some bitx 4 band boards from pcbway......Mr.?Wahyu Hidayanto says the board is essentially a bitx20 with of course some on-board band pass filters. I was looking for the BOM

Hi, I think you may find it easiest to use the firmware that has the "memory manager" software.? That way you can easily enter the default VFO and BFO calibration numbers, and then have a starting

Thanks Kobus!

No. All the software you need is that provided by HF Signals. This may be different if you are using some other software than that provided by HF Signals. Some systems do provide separate EEProm data

Most any audio amp that is capable of driving headphones or a speaker can be used to trace audio through the uBITX circuitry.? Use a 0.1 mfd capacitor as a probe to isolate the amplifier from DC.?

Hi, For importing to India maybe:? 8504.90.9610, or 8504.50.8000 73,? Mark

Oh oh! I just saw this On the diagram of the Ubitx V6 the capacitor is not polarized. (To see on your models) Me on my diagram , it’s polarized Maybe it is that? Anyway, I’m going to desolder it

hello, Hello, To clarify I have this problem on my 2nd prototype The first one had 12MHZ filters and worked well the first time. Careful, the implantations are different. The 2nd is in filters

By updating the EEPROM have I made irreparable changes?

Hi Gerard, You don't mention whether this is new behavior or whether it had existed since you completed your build.? I've had a similar problem after an upgrade, and it turned out to be a cold solder