开云体育

So I’ve established that the sBitx boots up with the same SD card using the Raspberry Pi 4 or an old Raspberry Pi 3 that I had on hand. But using the Raspberry Pi 4 that came with the unit the

Display is sold. Howard

There is an assumption of software over hardware for failures. There is a version of? software with a timing fix for the TX but it does not solve all of the problems but it does help. Likely you may

Using the multifunction knob for scrolling through the bands makes great (and logical) sense for that function. I should have guessed that would be the approach.

As to band table display.? My preference is a general up/down button pair that gets applied to the currently active function (highlighted) Band would be that function and a scrollable list with

a pilot idea with tablet or pc Pocket RxTx v2 - l’ensemble des fonctionnalités - YouTube ( https://www.youtube.com/watch?v=6-gDo0obACI ) ?metteur-récepteur uBITX avec affichage numérique à

Three possible locks came to mind.. Band edge for the ham bands (no tx if outside), Keyboard inhibit of other functions while "typing". VOX or audio TX disable while other audio sources are in use

For sale: ?Nextion 2.8" Enhanced "K" series display. ?I have enlarged the holes to fit the uBitx case, made a wiring harness for it, and powered it up to make sure it is working. ?However, I have

Another tip is to print the PTO form scaled to 110%. I got the brass nuts at Home Depot, they didn't fit the original size. 73, Mike AF7KR

I dead bugged (ugly) version on a sheet of G10 copper clad sheet. FIRST and foremost use 4.9152 or 5.0688mhz crystal to avoid WWV issues at 5mhz. Second lay it out in a fairly straight line for RF as

Its TX oscillation (yellow red screen) in the TX. USual case is finals blow and then possible U3 filaure. Your troubleshooting a hardware issue. Allison ------------------ Please use the forum,

Generally, for linux lowering the number of processes can improve response. The process table is large as seen from terminal running top.? A lot of the processes are for things like running the GUI

The scrolling would be bidirectional via the use of the upper rotary control (what you normally use to adjust volume or any other multiple selection button that has focus). At this point, any GUI

Mark, Use crystals that are not 5MHZ. You can purchase crystals that are slightly above 5 and some below 5mhz. WWV will be a pain, depending how strong WWV is into your QTH. Sent from Mail for Windows

I've was at 99% flash usage on my custom firmware, which picks-n-chooses from others and mashes in my own mods. Assuming you're modding & need some space & don't want to give anything up...? you can

“ *I’ve been considering an option in software to change the multiple band buttons to one button that scrolls through the bands, much like the MODE button does with modes* ” Please reconsider

hello, Here you? have some useful videos on the installation of the Nextion, Smeter and AGC. For questions about it Good day cdt https://www.youtube.com/watch?v=Km2pi2wEdBQ

Most others are far more knowledgable on here than I am, but for the S-Meter you need to get another Arduino Nano and add it to the uBITX. I have been attempting to Mr. Ian Lee's blog for it. You can

I've long since found mics and their characteristics need to match the users voice and the radio.? With SSB too much bass or high peaking makes for hard to copy audio as its also bandwidth limited

I kind of figured an RTOS would sacrifice the flexibility we have with a general OS. Not a route we want to go. Straight CW keying on the sBitx is reasonably good right now. I want to experiment with