开云体育

First I am very grateful for how Ashaar and Thomas have supported this effort going above and beyond and not asking a penny for the upgrades, thank you. But I do not understand the delay. I have

Hi All, Merry Christmas!? I hope everyone is out of the snow storm in the US. Quick question: Has anyone received their upgrade kit?? I ask because Thomas stated that kits were sent out on 10 Dec.?

Hello Doug, I have done the mods that you are looking at on a V6 with a 2.8" Nextion display.? The stock 5volt regulator was used, taking the 5 volts for the S-Meter amp off the encoder pin connector

It should have been "first uBitx," not "first uBotx"

Ratnabh, It might be RF feedback.? This happened to me with my first uBotx.? The solution was grounding, A common mode choke on the line to the uBitx from the off-center fed dipole to the shack, and

I'm working on a few uBitx v6 mods (AGC, S-meter, Nextion, etc.) Most need a source of 5vdc. Some folks are taking 5vdc from the Arduino Nano since I don't think there's any 5vdc on the main board.

Sir, Rx is comfortable Tx is distorted I have changed microphone . but this is not solved the problem. VU3EEX Ratnabh Prasad

Pretty neat -- '72 Aaron K5ATG

As I port KD8CEC to Raspberry Pi Pico, Teensy, and the newer members of the Nano family (Every, IOT, BLE, RP Connect), I discovered that the shear volume of combinations of processors and LCD far

Believe the 7" has the same resolutions as the 5". At least when i created the 7" "tft" that looked like the spec in the Nextion editor. Several 5" based designs that were just re-exported for the 7

Just remember you can not just resize the screen you have to redo the math for the meter sections to display correctly . Else you will have incorrect readings.

Thanks Peter . Yes last time we missed making the 7 inch display case. Since I already have a 7 inch Nextion so I thought it would be to try a limited run for it . Thanks for your interest. We require

Sunil, You might look at the T41 group and see how your enclosures could also be used there. 73 Mark -- AJ6CU KD8CEC 2.0, Nextion Screens,? and open source uBITX Raduino boards for Arduino IOT, BLE,

The WSJT-X program sends a CAT command to put the radio in USB mode as most FT8 activity is on USB. This can be disabled using the Mode setting on the Radio tab of the Settings dialog. -- 73, Mark,

I'd be interested in one of these with 7" Nextion face. It might be worth considering doing a limited run for the 7" buyandisplay displays as they are quite popular with some homebrew projects, if

HC49U crystals look like this. The S version is a short version. As Ashhar mentioned, grounding the case may have little effect on bandwidth. I wouldn't worry too much about it. Just make sure you get

Maybe not an answer, but FT8 on 7074 use USB, not LSB. Maybe is that a reason. WSJT-X set rig to USB.

Aaron, The crystals have four pins of which two can be grounded, you can leave them out as well. I havent noticed much difference either way. - f

I'm using my uBitx v6 with WSJT-X v2.6.0-rc5. On 40m (7074) I set the rig to LSB. But it keeps switching to USB. Why is that and how can it be avoided? ...doug, K6DRK

Thanks for the help Jerry. How do I know if I have HC49 crystals? -- '72 Aaron K5ATG