开云体育

That's unfortunate. I assumed HF Sigs would be on the commercial side of the fence. ?

No second kit here.? I got the 1st kit (5V switching regulator & 2 new output transistors) quite a while ago. Gerry Sent by the Linux Thunderbird

No, nothing here yet. Unit 135. I am looking forward to getting it. Phil KB3UUL

https://www.raspberrypi.com/news/supply-chain-update-its-good-news/? Supply chain update - it's good news! - Raspberry Pi raspberrypi.com

Raspberry Pis are being sold one off at the moment to individuals. They are also selling it to approved commercial buyers. We applied but received stony silence from them.

Glad you got it working. When I've seen errors in the upload status messages, the previous version is left loaded. I'm not sure there aren't other issues with the CAT interface. ?I just found that if

It's actually next to the button labeled Update, but the drop-down list lets you select the port. -- 73, Mark, N8ME

Has anyone received an upgrade kit yet?

Mark, I reloaded the firmware and it seems to be working. I remember the first upload status message came back with an error message even though the screen works. This time around there wasn't any

Mark, Where do I find this setting? It isn't in Config Setup or UI. Mike N2MS

Mark, The USE_SCEEN_DUMP is commented out. The USE_CAT_ACTIVITY is also commented out. That explains why I don't see it. Here are my settings: #pragma once // use the defines below to enable or

Also, under ports on the FLRig configuration, I see two versions of the same port: /dev/tty.usbserial-#### and /dev/cu.usbserial-#### (with the same number in ####). I don't know the differences, try

The correct setting is 38,400 N,8,2. It is set in main.cpp. I will have to update the documentation. Please check the defines.h file. Is USE_SCREEN_DUMP enabled (not commented out with leading '//')?

The latest update from the Raspberry Pi folks looks good. https://www.raspberrypi.com/news/supply-chain-update-its-good-news/ Reportedly there are about 100,000 units of Pi are flowing into approved

Hi How about integrating the board in the mic housing? 73 VU2UT [email protected]> wrote: -- One of those ... ...

Mark, I am testing with FLRIG version 1.4.5. I set up as per your FLRIG CAT setup diagram in the user manual. I verified my CCOM port settings via device manager. FLRIG Setup recognizes the CAT port

I have a new sBitx that has never been powered up or opened. I am asking $500 including shipping (USA only), and I'll forward the modification kit when I receive it. The reason I want to sell is that

Holy cow...418 wire antennas! Jack, W8TEE

Click on a link to see antenna details... Wire_Antennas_for_Ham_Radio | | | | | | | | | | | Wire_Antennas_for_Ham_Radio | | | Bob KK5R

Mark, Thanks for the explanation. Your code is a vast improvement on the original code. I'm spending more time on the uBitX than with my $$$ radios these days. 73 Mike N2MS