开云体育

Its metric, I just assumed that. I did the PTO using a older way plastic tube and meachnicals. Lacking a handy printer it was the easy solution. Allison ------------------ Please use the forum,

Aaron, Dr. Lee developed two different S meter methods.? One uses an LM386 amp feeding the available "A7" input that does not require a separate Nano.? The other is, as you stated, using a second

I guess you could do this for the mode selection as well.

Anthony, I don't know if you meant to respond to my inquiry or someone else's. I was thinking about a Lock button, much like on the uBITx V6 with the Nextion display shown on this link Nextion Display

So I’ve established that the sBitx boots up with the same SD card using the Raspberry Pi 4 or an old Raspberry Pi 3 that I had on hand. But using the Raspberry Pi 4 that came with the unit the

Display is sold. Howard

There is an assumption of software over hardware for failures. There is a version of? software with a timing fix for the TX but it does not solve all of the problems but it does help. Likely you may

Using the multifunction knob for scrolling through the bands makes great (and logical) sense for that function. I should have guessed that would be the approach.

As to band table display.? My preference is a general up/down button pair that gets applied to the currently active function (highlighted) Band would be that function and a scrollable list with

a pilot idea with tablet or pc Pocket RxTx v2 - l’ensemble des fonctionnalités - YouTube ( https://www.youtube.com/watch?v=6-gDo0obACI ) ?metteur-récepteur uBITX avec affichage numérique à

Three possible locks came to mind.. Band edge for the ham bands (no tx if outside), Keyboard inhibit of other functions while "typing". VOX or audio TX disable while other audio sources are in use

For sale: ?Nextion 2.8" Enhanced "K" series display. ?I have enlarged the holes to fit the uBitx case, made a wiring harness for it, and powered it up to make sure it is working. ?However, I have

Another tip is to print the PTO form scaled to 110%. I got the brass nuts at Home Depot, they didn't fit the original size. 73, Mike AF7KR

I dead bugged (ugly) version on a sheet of G10 copper clad sheet. FIRST and foremost use 4.9152 or 5.0688mhz crystal to avoid WWV issues at 5mhz. Second lay it out in a fairly straight line for RF as

Its TX oscillation (yellow red screen) in the TX. USual case is finals blow and then possible U3 filaure. Your troubleshooting a hardware issue. Allison ------------------ Please use the forum,

Generally, for linux lowering the number of processes can improve response. The process table is large as seen from terminal running top.? A lot of the processes are for things like running the GUI

The scrolling would be bidirectional via the use of the upper rotary control (what you normally use to adjust volume or any other multiple selection button that has focus). At this point, any GUI

Mark, Use crystals that are not 5MHZ. You can purchase crystals that are slightly above 5 and some below 5mhz. WWV will be a pain, depending how strong WWV is into your QTH. Sent from Mail for Windows

I've was at 99% flash usage on my custom firmware, which picks-n-chooses from others and mashes in my own mods. Assuming you're modding & need some space & don't want to give anything up...? you can

“ *I’ve been considering an option in software to change the multiple band buttons to one button that scrolls through the bands, much like the MODE button does with modes* ” Please reconsider