开云体育

Try one of these attached. 73 Evan AC9TU

*Hi John, been looking for the enhanced 28 file myself, but only other screen sizes found. could you possibly * let *me have a copy thanks Art g3xne*

forget about my last post .... sorry did not read carefully (you wrote it is SOLDERED to the ground lug?!?) ... so ok on that dg9bfc sigi Am 12.09.2022 um 12:34 schrieb lou_w2row:

i would try to find a better ground spot as to clamp it under a screw ;-) dg9bfc sigi Am 12.09.2022 um 12:34 schrieb lou_w2row:

Attached is a picture (if I can figure out how to attach one) of a factory modified sBitx which I received from my basic kit order last week. The black (ground) wire is soldered to the pad under the

*Hi Mark, do you have the nextion enhanced 2.8 screen firmware. am looking for a hex file to use with xloader. or whatever * you may suggest..

Hello everyone. My name is EBARA from Japan. My call sign is JE1JGC. I have ordered "sBitx Fully Assembled" and am waiting for it to arrive. In order to use sBitx in Japan, you need to follow a

Hello, see this post [email protected] | Some calculations on the IF filter and USB filter (

Which model of Bitx is this ? Sounds like some SMPS spurs drifting. Raj, vu2zap

*Hi all, has anyone got the 2.8 Nextion enhanced files available, can only find 3.2 inch, would appreciate your help. * Art G3XNE

My bitx has fixed noise issue from 21.3180 to 21.3480 Mhz ,how to fixed that noise. Attechment bellow

Yes, I have been collecting the screens. They were scattered all over and was hard to find for a new owner of a uBITX. I am sure that there are some hidden gems there. On my todo list to try a few.

I did things a bit differently. I removed R79 and R80 (the voltage divider is no longer needed or wanted) and shorted the R80 location with a solder bridge (a short piece of bare wire or an SMD 0 ohm

Anthony - from what I have seen on the Wi-Fi interference, the best solution is to disable the w/f & use an ethernet cable. Gerry Sherman Sent by the Thunderbird

I just installed a new LM380 with a socket and it didn’t solve the Wi-Fi interference issue for me. It did however improve the audio quality, especially at low volumes. I say “new” LM380, but it

Goody, It might be better to solder the ground to the nearby mounting hole's tinned collar. The switching regulator needs a low impedance ground. - f

Goody, The guys ar HF Signals were saying that these are faulty LM380s. A replacement works without the interference. I will attempt this on my own board and report back with week.

1. set potis to minimum current 2. Select Mode as USB. Reduce the MIC to zero. 3. Press the PTT. 4. Without speaking into the microphone, carefully increase the DRIVE_BIAS POT until the current

Has anyone attempted to troubleshoot this issue recently? This evening I placed a grounded piece of PC board on top of the LM380 and also tried 0.001uF caps between pins 14 & 3 and 7 & 8, to no avail.

Mine arrived in Friday’s mail. Thank you, Ashhar!