开云体育

I know this is a year late, but i would continue to build it,stockpile it and either take it over to india,and other countries that would appreciate the medical equipment to save lives 73 David ac9xh

Evan I have Two ubitxs and I loaded one with N8ME and one with N8ME with VU3GAO mods and I am getting the same. No side Tone for CW. I sure the CW is Selected I sent used key and my watt /swr meter is

*Hi? Evan,? just compiled and uploaded? the vu3gao mods? firmware, and i? get the same result.. seems to be working ok*

I am worried too, I have sBITX s/n #0052 but haven't received an upgrade kit for it yet. -- Stephen, KO4CVU

Dear self-described grumpy old man! What a hoot! I think you missed a few details? I don’t make these boards at all. I don’t sell them either - so maybe that’s why I don’t advertise a price???

Gordon, I clicked through all the stuff to see about getting a PCB for the reverse voltage protection device. After a few pages, I was disappointed to see an asking price of USD$28 and change.

*THOUGHT SOMETHING WAS UP,? THANKS EVAN*

Art, You do not have the correct software.? Go to this file and download it: /g/BITX20/files/uBITX_6_N8ME_2_VU3GAO_Mods.zip Then follow the instructions on Farhan's video to compile

It is concerning. If they really were shipped out by USPS last week, some people should be getting them by now, and others would have gotten the upcoming delivery notice if they're signed up for

Still looking for the files for the toroids if they're available.? If not, I'll take a shot at making them myself. 73, Dean KK4DAS

*TKS Howard, have just loaded N8ME firmware ver 0.1.. * *Have? boot screen which shows 3 lines of data, * 1 = band - splt - 200 - finp - rf att 2 = usb? ?- rit? ? - tune - cfg - cw spd 3 = m1 -

My concern with the upgrade package is that I show no inbound packages in my USPS account at this point, and haven't received anything yet. --Neil, W2NDG

Hi Chuck, Two things come up to me as to loss in sidetone: 1 - The N8ME configuration 2 - The Nano has a hardware issue To address problem 1, verify that CW is selected on the main page and that the

Just replaced the Arduino Board and Main Radio Board. Figured I look in to the Firmware of N8ME try something different interface. I been doing CW so this was suppose to make the uBITX more CW worthy.

Pulled out the finals and only Q18 was bad, Q19 survived. Probably replace both just to be safe though.

This is good timing, I just let the magic smoke out of #077 (accidental high swr I believe) Burnt the large traces near C11 and C85, I'm assuming I can replace Q18 and Q19 and resolder those traces.

The shipment delay was to refit the existing orders with the switching regulators. So, yes. The new orders also have the spare IRFZ24Ns anyway. - f

Will all new orders include those parts too? ('cause I almost have enough penny's saved to make an order)

It is not really an upgrade kit. It is more a replacment kit. It has a switching regulator as a replacement for the LM338 that heats up a lot. It also has spare IRFZ24Ns just in case.

Whats in the upgrade kit? --