开云体育

Jonathan, The issue comes in that the newer (i.e. more recently purchased) screens require the use of the latest Nextion GUI editor. And for what ever reason, the latest version produces code that

*Aaron, * The best solution is to get a new card.? Amazon has them with next-day delivery if you are a Prime member.? The low cost is not worth waiting to spend the gas to go to the store.:

The party continues. Evan I'm pretty sure that both of the Nextion Displays (2.8" & 3.5") are basic and are touchscreen. The SD card that I was using was no good. Now the only Micro SD card that I

Hi Jonathan, Your statement is correct for the software in the Nano on the Raduino board.? For the 1.2 version of the software, you need to know if you have a v5 or later uBitx, the type of display

I went through all of the posts I could find about the difference between the basic and enhanced Nextions for the upgrade: I may have missed something in the volume of posts, but the prevailing

For VHF work, do not ignore the lowly brass. They make excellent cores for toroids as well as solenoid inductors. [email protected]> wrote:

I have used solid teflon on hf. It gave good result but the best is RF grade Nylon.

The test would be to measure the Q of a solid 3d printed toroid vs a hollow form one, I couldn't find any posts about that, are there some here?? G3YNH talks a lot about materials, but mostly

I am updating the stl files. I will link them up on the blog page of the Daylight radio. - f wrote:

Never mind, sorry, I just re-read Ashhar’s post: “Ashhar Farhan Aug 15 . . . The inside of the toroid should be hollow and it not hollow it should have as little in-fill as possible. This is the

Here is one of the 25mmToroid.stl files printed in PLA at 5% infill, then cut open with a small angle grinder. It looks like more internal open space is needed. Has anyone figured out layer thickness,

Been staring at the source for Ian Lee's standalone S-meter and SWR. See https://github.com/phdlee/dspmeterv1 In uart_forward.cpp, at line 75 and 78 we have the definition of PINs for passthru of the

Aaron, That is a basic screen.? Is there an R or N after the number?? If an N, then it is not a touch screen. https://nextion.tech/datasheets/nx4832t035/ You can test the file load using the

Evan, Can you share the HMI files? Trying to collect all the Nextion screens in one place. See https://github.com/AJ6CU/Nextion-screens-for-uBitx-KD8CEC-firmware I am not sure I have your designs? 73

Thnks Evan, I'm pretty sure that I have the basic one. Here is the number NX4832T035_011 -- '72 Aaron K5ATG

Hi Aaron, Thank you for the compliment. The correct file to use with the Nextion microSD card de[ends on the model of the Nextion display.? I would look up the model number on the Nextion site to see

Where can the .STL files for the 3d printed plastic toroids be found? The PTO VFO one I have found easily. But the toroids are proving more elusive. Or is that left as an exercise to the homebrewer? I

The IF would be another one that would benefit greatly from a per band stored setting. If you make some changes John would you mind sharing them on here, I want to "fix" that issue with the IF but

Ah, I expect folks were discussing ferrite toroids used in power applications (antenna and PA transformers) where designs have to be well done or else there can be high losses and/or damage to the

I found the /home/pi/sbitx/data/user_settings.ini file that lists the starting values. Now to find the code that should keep these values current Band/Mode session to session. John