开云体育

This may be the same board. ”Funtronics uBitx digi interface installation in V6” /g/BITX20/topic/funtronics_ubitx_digi/73254403?20,0,0,0::recentpostdate%2Fsticky,,,20,2,0,73254403

I managed to get what seems to be the last?Elekitsorparts uBitx Digi-Interface in stock at Tindie.com. Of course, it came with zero instructions and a link to a YouTube video that shows installation

Hi John, It's not menu driven in factory firmware. No switch / Arduino pin value to sample to change step size. Step size changes based on the the number of encoder pulses captured during the sample

Is there a menu choice or switch to change tuning rate? I must have missed it. Pushing the vfo encoder gets a menu but I don’t see a place to set that. -John N4HNO

Ashok, Try the method given in this manual for the N8ME software.? There is a section in the CFG menu for frequency and BFO calibration on page 8.

Hi Andy, I figured it out. I just had to swap the input and output around. Now enjoying full power! Thanks & 73 Tim N7LVB

Tim, For sound card modes, output power is varied by adjusting the sound output on the computer.? Are you using a sound interface like a Signalink with a volume control? Try sliding the lower-right

When I key up on 20m CW or SSB I get full power output (5-7 Watts). But when I use WSPR through WSJT-X I can only get about 1/4 watt output. Any ideas? Tim N7LVB

Paul, The sbitx is not a simple rig, it is minimally designed. It has an in-channel dynamic range of 80 db. That means, it needs more than 16 bits of adc resolution. The wm8731 has 24 bit resolution

also, make sure u use an attenuator on ur nanovna,qrp transmitter? so you dont fry something in the ubitx. 73 David ac9xh

I think i meant transceiver,instead of receiver. sorry. 73 David ac9xh

Ashok, 1.Dont try to calibrate the ubitx unless you have a problem.I never did any of the "calibration stuff "others tried.Only thing i did was install n8me software on? my ubitx. took care of the

Curious why you went with the wm8731 codec? I've never used one. What is its claim to fame? That thing looks pretty crazy to me for use in a simple rig.

Hi all, I am new to uBitx and every then and now I am having one question in my mind. For this time can anyone help with alternative method of calibration because the VU2ESE method of calibration

In the first ru, we will probably have 50 basic kits and 150 full systems. I would also mention here that this is a developers' edition. Familiarity with raspberry pi, ability to use command line etc

On Fri, Jul 1, 2022 at 08:19 PM, Ashhar Farhan wrote: > > Scott, > We will still be giving out the basic kit at a much lower price (about the > same as the ubitx). > The main board is almost twice the

Hi We use following applications with or withour vcoder dongle 1) Peanut 2) BlueDV Software with USB Dongle 3) Droidstar ( works on IOS/Android) 4) iax DVSwitch on Android /IOS 5) zello (non Ham) but

Awesome! ?Thanks Ashhar Scott

Scott, There is a provision to run any other software (I started with wsjtx) using the last of the mode settings : digital. You can run these additional modes like you would on a conventional radio.

Hi all, I just installed the N8ME firmware with VU3GAO mod and now I need to do calibration. I cannot find any guide to do calibration of uBitx with N8ME firmware. Can anyone help me ? Thanks Ashok