开云体育

I'd suggest trying to sell it here, shipping back to India seems expensive. If you want to pursue a refund, contact hfsignals@..., rather than post your question to fellow kit owners. Their

Thanks guys.? I believe it's a V4.? No key to clean as I just plugged in a double ended cable and shorted the end. I will do the voltage checks as you suggest. Andy KM4TRT

I paid for and received a ubitx, which remains unassembled. I want to return it and get a refund. How do I get a refund? -- -- Dave, W3DJS ( https://www.qrz.com/db/W3DJS ) Technical Specialist, GA

I'm looking forward to seeing? your new radio. Leonard KC)WOX

Vic, Remember to check R83, no need to desolder it but check in situ with a multimeter. Raj

Andy, Skip's recommendations are good to follow.? To restate what he said,?CW is generated when the Nano sets the first LO (CLK#2) to the RF value (either the dial frequency or the Dial frequency

Hi, For anyone that may be interested, I just checked what version uBitx I have -- that I'm running on 14.0 volts. Looks like I have a V3 (2017) board. The audio amp is a?UTC2822M. The chip is

Curt this statement you wrote is incorrect: Note the ubitx makes cw transmit by leaking 45 MHz RF direct through the last mixer. On CW transmit the clock #2 to the first unbalanced mixer before Q90 is

Well I found what was causing the voltage problems...after checking all around the system I recalled that I had replaced a leaded 2N3904 with a 2N2222A for Q90 since they are equivalent, right? Well,

Check the solder joint on the cw pull up resistor. Oh and check your key and wiring too. Note the ubitx makes cw transmit by leaking 45 MHz RF direct through the last mixer. I am doubting likely

Hi, Most picture formats are blocked from going in the Files section, so they should be going on the Photos section. For me too, it is much easier to set the emails to specian notice only, and then

I have a new, assembled uBitx V6 available.? I received it new in January and out of box, I could not get it to work well in CW mode, which was my intended use, and the mic was inop, replaced by HF

It depends on the band your on what the output is .. did you use a diff band ?

Hi Folks, I was tuning up my u-Bitx by shorting the cw, which usually gives me about 9 watts and all of a sudden it stopped. The SSB still works fine, showing about 5 watts on the meter.? Anyone know

Richard, Here is the URL for the Amp.? Costs about $5 altogether with shipping and 3 weeks. https://www.ebay.com/itm/264547217763 Andy

Ashhar, Thank you so much for all your work on this project.? I am hoping the sBITx will be my first HF Transceiver, and I eagerly await its availability. I have a few questions: Firstly, If a 3G/4G

Doug: I did not see such an option, but I wasn't really looking for it. I'll do that tonight. Jack, W8TEE

I agree with these sentiments. For most of the 90's I was stuck with dialup service while the public use of the Internet was exploding. The developers and 'Influencers' all seemed to have unlimited

Jack's very valid point about server usage aside, I highly recommend you go to /g/BITX20/editsub ( /g/BITX20/editsub ) and change your e mail delivery preference to

That's not the issue. Each post is stored on the groups.io server and the capacity depends on the type of account you have. My group is much smaller than this one, but four years ago members ate