开云体育

While these mods work, the one with 2N2222 need to be managed by replacing the capacitor value which has to be around 470pf such. Dont remember the blog.

I am getting some sort of transmission when using the mic normally, I can hear it in a near by receiver. I can also adjust the side tone frequency and hear it during the setting of it. However, I get

The DROK clips on Amazon look well built, I may get some. You have a choice of 50cm and 100cm long. Wire used is said to be 22 awg, from the photo it's 19/34 (19 strands of 34 gauge). The 34 gauge

Hi Todd, Try removing the key and using the mic PTT to see if the CW transmits and if you get the sidetone.? The CW menu selection does need to be on. I suspect that your straight key uses a mono

Is the rx working?

Hi Jonathan, Impressive mods to your rig. I would add to Raj's suggestion that you check around the L5 and L7 mod.? Since CW does not use the BiDi amps, and you did modify the connection from the

Just got my uBitx V6 full kit. After completing construction and connecting the antenna and power, I turned on the radio. I plugged my straight key into the key port, and the radio went into transmit

Does the receiver work ? if it does then check if you got voltage on TX in the bidi amps. Q21/21/22 and Q40/41/42 ? Raj

Hi everyone, I applied some mods to my ?BitX v4 tonight. In general they seem to have worked, but I also seem to have lost the ability to transmit using SSB (CW seems to work beautifully). I was

I actually gave this a go, but discovered that my particular AGC's output wasn't very useful, and I didn't polish the feature at all, so didn't publish the code. Reed

Hi everyone, I've been hacking on my BITX40 since my late wife bought it for me in December 2016. I broke last year, and I just got it fixed and upgraded this week. Moved the IF to 11.0592mhz,

Dude check adafruit they have mini clips lady ada uses them !=8)

Hi please tell us the price in USD so I can pay. It looks like one board is going to cost me around 10 usd perhaps I'm wrong but sounds about right. Then whatever shipping costs. wrote:

Hello Mike , try Hirschman products : german quality . https://www.newark.com/hirschmann-testmeasurement/930317801/alligator-clip-4mm-red-8a/dp/97K4292 73 HB9EFN Georges

hi James, I do not know of a firmware version that has an S meter function and works with the stock v6 display.? The CEC versions work with either a character display like the original 16x2 display

If the S-meter code was written for the Nextion, yes, you will need to alter the code. To me, the Nextion has a weird way of displaying things, requiring the use of their editor. Perhaps the good

Sorry for the maybe naive question but here it is. i have the uBitx v6 if i wanted to change the firmware to one that maybe compatible with a s-meter do i need to change the tft screen that came with

You might? also look for "battery clips".? I have found some of these to be a bit better, although they are bigger (and a bit more expensive). Sent by the Thunderbird

Looking for the best?... Mueller https://www.muellerelectric.com/products/category/Clips