开云体育

Jerry and Curt, I had the chance to pull L4 and C204 this morning and substitute a 47omh resistor (too lazy to look for a 50ohm in my stash).? I believe that the results confirm what Jerry

Huh. Guess you missed the JackAl board and the other Hycas circuits discussed here. In all fairness most people only need an automatic volume control because they will not discriminate between the

These are the changes to all the versions of ubitx. your mileage will vary. i have tried it on my own build, I have asked some colleagues at HF Signals to try them out too, you might want to wait for

Ashhar Farhan said: Thanks for that.? Would these be things we could try on a uBitX v6, or is this specifically for the SDR unit you're working on? Thanks! :-) Will B AF7EC

Well, that didn't work the way I thought it would!

Gerard, On your "tandem match" your single turn (through wires) are the larger wire.? I put the large magnet wire through a piece of insulation from a 14 ga wire to make this.? On the smaller wire

http://www.hamskey.com/2018/08/ubitx-firmware-cec-version-1097beta.html

uBITX Firmware CEC Version 1.097Beta Release(Include Nextion, TJC GUI Firmware V3) (hamskey.com) ( http://www.hamskey.com/2018/08/ubitx-firmware-cec-version-1097beta.html )

Here is your file attached.

I've been?looking for the HEX file for the DSP Arduino for the S-meter. I've read through the links http://www.hamskey.com/2018/07/standalone-signal-analyzer-i2c-type.html and

All, I did confirm the same CW mwaveform issues at TP1 on my v4 ?BITX.? Since it is a spare and not assembled into a nice case I will use it to hunt down the possible issues with the 40meter CW

This is an interesting report. I havent noticed it on my ubitx. I should ask HF SIgnals to loan me a standard issue ubitx and check it out. As many know, I am working on an SDR. I am using a modified

I ordered some LM358 chips so we'll see what happens.

No complaints of distortion, just relatively low power out on 40m CW. The 40m SSB transmissions don't seem to be affected. The v5 and v6 are pretty much identical, except for the display and

Clay - This happens on my V6, less than half output on CW opposed to LSB... 73, Justin B. KI5GKD

All the AGC schemes for the uBitx I've seen thus far have audio derived detection of the signal level. to create a control voltage, that control voltage is then used to attenuate the signal at some

Clay, Just to answer your question with at least one data point, my v6 power output has a dip in the CW portion of 40m. I always assumed it was because of LPF tolerances. Rafael PU1OWL

Just to clarify: Is the issue being discussed, some rigs showing low power output on 40m cw and/or distorted output on 40m cw, only occurring on v5 or previous, or is it also occurring on v6? Clay

Evan I am looking forward to your results with your v4, but indeed do enjoy the significant holiday with your family, no rush. I do think those with a pronounced dip are rare in v4. Look for Ashhar's

You may have something there, Kobus. I wondered if the AGC operating back in the IF stages would limit things such that an S-meter reading audio level would always drop back to something lower,