开云体育

I also used this on the antenna input for a while before I built my own filter. It worked ok. Definitly killed the AM interference. Their may have been some slight attenuation of the transmitted

Kit-projects sells a uBitx broadcast filter kit on the web page where they sell their agc board. It requires you to wind 3 tiny torroids but it works well. There is another design you can build

Bore da, Arv! Sut dych chi? (Dw i'n dysgu siarad Cymraeg!) Related? There are teeming millions of we of the Evans clan!

Hello, The other time when I did a search on E.. Y, with the keyword Ubitx, I came across this. A filter, but I don’t know any more...

Bob, I would agree with Gary's suggestion to add the Broadcast Band high pass filter. I had a similar experience to your son's one afternoon.? All of a sudden I had birdies all over the band.?

Patrick, The v5 firmware uses a different SSB filter frequency.? That software will not work with a v4 board.? Here is a link to the KD8CEC software that has both the v4 and v5 board software.

It's been lots of years since I have looked at huff-and-puff oscillator stabilization. What I wrote in that last post is incorrect, there's more going on here. Jerry, KE7ER

So it seems the Huff and Puff method is for providing the final little bit of frequency stabilization to a VFO that is already adjusted to oscillate very close to the desired frequency. Would the Huff

This may be an alternate way of looking at what you are proposing. I suspect you are describing a phase-locked-loop. And that yes, you have tried it. There's a phase-frequency-detector inside the

That was a typo. The chip is the ATTiny841. Tom, wb6b

I was expecting Arv to write in about H&P schemes. Between him and Hans, there is all we know about how this scheme works. The challenge of Huff and Puff is that it needs a very stable oscillator to

The Arduino (ATMega328) can count external clocks up to 1/2 the clock used to run the chip. With a 16mhz clock for the ATMega328 that would be external frequencies up to just shy of 8mhz can be

Can you hear static or at least an increase in background noise as you plug the antenna in? Perhaps bring a wire from the antenna connector over near the 25mhz crystal of the Si5351 on the Raduino,

My son did not have time to go into great detail. I'll find out and report it later. My son lives about 3000 miles away (KY to CA) so while swapping radios to see if the problem follows the radio is a

I put a home made broadcast band filter in the rf Path of my one bitx and a kit one in the rf path of my v6. They kill broadcast AM interference from KDKA which is a 50kw blowtorch not 10 miles from

Maybe try swapping uBitx's with your son. See if the problem follows the rig or stays with the QTH. Out of curiosity, do all these extra carriers move at the same speed as normal signals as he tunes

As many of you know, I gave my V6 to my son in Sacramento, CA. He's an avid QRPer and would rather make a contact with low power/QRP than with a kilowatt. His first impression is that the radio is

This H&P jitter may not matter much if it isn't very frequent. If it's a second or two between updates and the frequency slews at a reasonable rate after an update, the "jitter" should be no more

Hello to One & All... Put together this uBitx . I have double checked all the wiring and all is correct . But when I power it up all I can hear is hiss from the speaker . I uploaded V5 Firmware but

Gareth Evans We have the same last name...are we related? 8-) H&P stabilization is interesting because by default it sets the tuning step size as well as holding frequency drift to around 1 Hz,