开云体育

ubitx v4 is sold. Thank you all.

Yes, and you replied to my post on your QRZ page. Many thanks & best luck always, Ted

Did you see the for sale post earlier today? /g/BITX20/topic/bitx_40_for_sale/75828504?p=,,,20,0,0,0::recentpostdate%2Fsticky,,,20,2,0,75828504 Reed

Looking for a BITX40,? complete kit without case or with, but case not of interest; a special packaging project awaits.? Also in market for a ME40+, 4-State QRP, or similar minimalist 2-4w VCXO QRP

Roger Now have a sketch and library installed and looking for cable.?

Hi Ted, it appears that the github user interface has slightly changed, Instead of "clone or download", click on the green "Code" button and then choose "download ZIP": 73 Allard PE1NWL

search for WB7AVU in QTH or QRZ for sale ads

Hi Reed, I installed your software in a V6 for another ham. Nice job:) When you get one for V3 and stock display please let me know. Maybe I can learn enough about the programming top transplant some

Stock v6.1 code reverts the calibrations. My version does not. Reed

Hey Evan, Really I think the only difference between EasyDigi and my setup, is that the Teensy + Audio Adapter takes the place of the sound card.? The added capability of the Teensy is that I plan to

Hi, I did the calibration on V6 with the stock software and it did not remember of show the previous cal numbers for the VFO. I had to write them down. As I recall the BFO was less troublesome. I

The Gerbers are freely available, you could have boards made yourself.

The short answer is yes.? The longer answer is that as long as you use the same Nano, the values are stored in the EEPROM area that is separate from the program area.? If you do swap out the Nano,

Sorry, it is sold.

Can the numbers that I use when calibrating the radio using the CEC software and original TFT screen be used with the Nextion? Are they even close? It would be a good starting point for setting up the

Thanks Arv: I'm really resisting the s/w route b/c this unit will be handled by club members. I want to keep the reliance on s/w confined to the original ver. The guys at the club can handle hardware,

Thanks Vic and Dave Not sure how I got there but now have a sketch called Master Bitx compiled okay with included library. Had to stop there as found I don’t have right USB cable connection for

Hello, I have been trying to contact him too. The email he left looks like it goes to spam. I really could use this board but I won’t pick a fight over it. Chris

Mike -- sorry to be slow, but I can't figure your email.? And yes I'd love this board in my uBITX!! Dontay155[@gmail.com]

Ted , click on the green ncode button and a popup will show you a download link Dave kc2ipx wrote: