开云体育

Ray, There are 7 2n3904 transistors that should be on in a linear bias plus the LM386 audio amp when in receive.? If you have wired the power correctly (the RED wire is the +12volts to everything

Hi Ted Thanks for the reply. No the Raduino was not connected the picture in the documents doesn’t have it connected Regards Ray Sent: Thursday, 9 July 2020 11:24 AM To: [email protected] Subject:

That's what it should read when the finals have had their bias adjusted iirc

Yeah, I don't know what bloat was added, but there's a reason I called out the specific IDE version in the Readme file :) Reed

Hi, Ray. Is the Raduino connected? Ted

Hi I purchased a V5 last year and am only now starting to put it together. I have wired up the DC power plug as per the instructions and the instructions tell me if I apply 12v it should draw between

All compiles fine under 1.8.9... the updated libs in 1.8.13 seem to cause bloating...

What version of Arduino are people using to compile this ? Thanks!

Dale, Correct save for NOS abounds and also poor quality copies. Its more be wary and careful. Allison --------------------------------- No direct email, it goes to bit bucket due address harvesting

Bob, Mounting from the back side was only part of a complete mod.? Do only partial and you get poor result.? Basically for that iteration a half fast fix was not a fix at all. See the wiki for the

Found it,? installed it, and it works great.? Thanks again. -- Lee - N9LO "I Void Warranties"

Tried to compile this on 1.8.13 and.... "C:\\Program Files (x86)\\Arduino\\hardware\\tools\\avr/bin/avr-size" -A "d:\\tmp\\arduino_build_194091/ubitxv6.ino.elf" Sketch uses 30754 bytes (100%) of

I suggested mounting the relays on the opposite of the board's ground plane as you say back in the days of the V4 and I remember someone trying it. The results from him was it provided no great

Hi Allison, While that is still true of type N, 75 Ohm BNC’s changed over to the same diameter center pin as the 50 Ohm version some time ago. In order to maintain 75 Ohms, the dielectric is

Hi Ken, I did Alison's changes for the relays on my v3.? It might work well for you, as with the relays mounted on the bottom side, their pins all end up on the top side where most of the traces

Ali express you can buy it. [email protected]> wrote:

When I see a 50 ohm BNC receptacle that is unreliable its likely because someone plugged in a 75 ohm into it and sometime verse visa. They have different plastic sizing and the center pin and socket

Some may not be aware that if you remove the locking ring from a BNC male connector, it will plug into an N connector. Shops sometimes make quick-connect jumpers this way.

Tim, I see your kit for uBitX! It looks like I can install it on my v5; not too hard. ?Do I understand correctly that it can be wired to drive the SMeter In the faceplate of my inkits case? If so are

Hi Dave, There are a bunch of off shore connectors out there that are just a mess. If you stick with named connectors- Amphenol, Connex etc, the center pin spreading is not an issue. I also use