开云体育

Thanks Evan for the quick response. I will try. Shall keep you posted. Regards Rajesh

I am concerned about this as well. I placed an order yesterday for a uBitX V6 and I would like to know if there are currently any delays in processing orders.

Looking for a V5 board, don't need controls or case, but will buy all if you prefer. Thanks for looking.......

For what it is worth, I worked about 8 hours of SSB phone this weekend on 40 meters with a single TalentCell 3Amp Hour battery 73, Dean KK4DAS

Rajesh, I am not familiar with the larc version software.? I am pretty sure that it will not work with the KD8CEC Memory Manager, though it does appear to have a CAT routine.? A quick look at the

I might try to use the existing Keyer plug to see if this would work, but the RigPi is not CAT control setup for uBitX so can't CAT connect naticely to RigPi will try and emulate the Yaesu 817 CAT

I like this solution.? I am using RigPi which has a PTT remotely controllable so I think I'll wire to this same line to see if I can CAT control the PTT to allow Digital TX control.

As a side note the Arduino Nano is ~$22 from Arduino.cc (yes cheaper from other sources and board manufacturers); from the same source, the arduino-yun-rev-2 (which is the newer version) is ~$45 so

This is the version I am using

HI Evan, Many thanks for the quick revert. My call sign is VU3RHU and my QTH is Mumbai - 400004. I am using the ver 3 stock software which I got with the unit in December. I have downloaded the 1.11

installed it in my v6, double checked wiring(although the agc speed wiring to the switch was a bit confusing). When I first installed it signals passed through but could not discern any agc speed

Hi Mark, Try the same test into a known, good 50 Ohm termination. This problem could be common mode on your feedline leading to RFI. GL., Dale W4OP Sent: Sunday, June 28, 2020 2:00 PM To:

Using the power mic, I finally see the needle moving on my meter, but now I have a new problem: "Fast Tune" blinks during tx and sometimes it gets stuck on tx and I either have to key in the mic a few

Lee You are correct in posting here. This is the group which handles "all things uBITX". There are other URLs which claim to represent both Farhan and HFSignals, but *Farhan does monitor this group*

Hello, I was wondering if anyone has had experience with integrating either of the following two AGC kits into the uBitX V6? https://amateurradiokits.in/product/agc-kit-for-bitx-and-ubitx/

Todd: Absolutely true on all points, but for some of those goals (e.g., WIFI, bluetooth, etc.) there cheaper and considerably more powerful options (e.g., the ESP32 @ $10 instead of $45) available.

Sorry, I did not know where to turn for help after 10 days went by and no reply to my email. The link you posted did not work for me.? It shows up as???? sales@ with 3 dots behind it in my

Hi all I’m new to building arduino projects (which are great fun by the way) and I had successfully built the arduino based magnetic loop controller by Lofturs. With that success I wanted to add to

Rajesh, The current KD8CEC Memory Manager version I believe is 1.11.? Here is the link to the GitHub repository: https://github.com/phdlee/ubitx/releases/tag/v1.11 And Dr. Lee's webpage that explains

Hello Lee, At the very outset we would like to inform you that this forum is not a place where the sales matters of HF Signals are discussed. This is a uBitx forum for discussing the technical issues