开云体育

Hope this helps... 73, Tom - N8TPN

He just asked for an explanation. Sometimes just a simple answer is adequate. Please try to stay on-topic _._

One way the knob will turn right to increase frequency. The opposite way the knob will turn left to increase frequency. Which way does your client want it to work? _._ [email protected]> wrote:

Yes this has changed with newer verions and it may indeed be confusing, On the newer Raduino's, the 5-pin connector shall be connected to the right side of the 16 pins line. See also this posting:

Thank you. I have now ran into something that is confusing. On the HF Signals website, on the BitX40 Wireup step three it shows this pic Looking on the back of the Raduino Assembly it shows an 8 Pin

Hi Aaron, This is viewed from the backside of the tuning control. 73 Allard PE1NWL

Its not mine, I’m building it for a friend. 72 Aaron K5ATG K5ATG Blog Sent: Thursday, April 9, 2020 3:10 PM To: [email protected] Subject: Re: [BITX20] BITX 40 Kit Build #bitx40help #bitx40 Why not

Alternatively build a cold war sandwich. 602 →xtal filter → 602

Much appreciated that you do build the best offering from Farhan

In other words, sort it out guv! This is not hard and the bitx40 is de puts madré [email protected]> wrote:

Why not wait until the new newer than new ubitx2020? [email protected]> wrote:

I'm putting together a BITX40 kit from HF Signals for a friend. It has an enclosure that looks like it came from Amateur Radio Kits. I'm at the point of connecting wires to the Tuning Control. The

Praba Karan, If you used a different Nano to upgrade to the KD8CEC software, then you will need to recalibrate.? The calibration data from the factory is stored in the EEPROM, which is not

Bob, is your V6 still available? contact me at my email if it is don

Karan Those Bafeong microphones are what I was thinking about when I mentioned opening the audio hole in the case. They are notorious for having too small a hole or having the hole offset from the

I am using modified bafeong speaker mic

Karan Are you using the microphone cartridge that came with your uBITX V-5? Several people have tried to use other microphones and experienced low audio level (low SSB output). Some resolved the

Recently I assembled ubitx V5 in? cabinet after a year long wait in my shack. Ubitx V5, CEC v1.2 firmware Nextion display, modified bafeong mic. Receiver working nice but with low audio like in V4.

I know this issue has been addressed many times, and I need some hardware, not theory to enjoy the fruits of my labor. My bench is a small desk with a VOM, and loads of hope to actually see what is

Nice simple instructions Jim, Thanks. -- 73 Mick VA3EPM p.s. We still have to watch out for “ID ten T” errors. :-)