开云体育

Try going into the setup menu and doing a screen calibration. That was needed on one I was playing with. =Vic=

!! volts may be too low. Try for at least 12.5 .

hello i have just finished my ubitx v6? the diplay comes up ok shows bands etc and there is a hiss from the speaker but the touch display is not? responding? im running at11v? and the ammeter is

Where can I find the instructions on how to update the stock firmware with the latest (stable) stock firmware?? Mine came with 6.1 so i assume I want to update that. -- Mark, kb9woo Milwaukee, WI

Hello all, The annual Sasquatch Stomp is just a week away, occurring on April 3rd, next Friday. Check out the details here. https://sites.google.com/site/pnwqrpgroup/sasquatch-stomp This is a fun

Hi Folks! How to connect this microphone to Ubitx?

Agree...Take Care wrote:

In these trying times my thoughts are with Thomas, Farhan and all the elves who do such a great job of winding toroids, assembling and testing boards for our technical challenges and learning. May

Vic, The V6 kit without case comes with 'templates' for front and back that are fairly thick, looks a little like plexiglass with an opaque covering.? Too thick to use as the volume/on-off switch

You do have the mode set to SSB USB right? 73 Evan AC9TU

Rene, Based on the recording, I would try adjusting the BFO.? It sounds like you are getting the carrier through when you press the PTT button.? See if you get the same sound with CW mode.? CW

Hi too, That is good you are on a capable power supply so we don't need to worry about that. On the 20m band, mine requires around 1.7A on CW (I still need to measure SSB) for 5.4W out.? Your

Hello again, did some measurings with mulimeter. The radio pulls when receiving on 14.250 mhz, about 280 to 300 mA, when TX its jumping from 850 to 1100 mA by 13.8 volts, the strange thing is when i

Because of the many problems I have with my V6, I also think that it is the software and so I also extracted the master file, problem is as soon as you load it in Arduino, you get error messages

Thanks, Russ. As I mentioned, mine is a V4 uBitX built over a year ago and no case or template was offered at that time. However, the Banggood case is easy to work with and I had used it on a BitX40 a

Open My Computer, navigate to where you unzipped the files. Change the folder name to match the ino name. Then double click the ino file to open it. Reed

Hello Mark, in the main time i have an 13.8 volt/10A power supply,bought it almost 2 weeks ago so the battery's are in the drawer. Thanks for reply Regards Rene

Hello VA6TD and all others, We have a complete lockdown in place in the whole of India and we at HFSignals are not shipping any orders till the lockdown is lifted. DHL and India Post too have

Hello India is on complete lockdown until 14-April and only essential services are allowed. No flights are allowed as well. 73s VU2TUM

The best antenna? that I have used are antennas that are large loops. The signal strength is comparable to a dipole but the noise floor is lowered 10db approximately. Our previous loop was 1300' and