开云体育

Go for it Ravi, good find! much smaller fooprint. Raj

Hi, Doing some further research, are there any off-the-shelf transformers that can be used for T5 and T6 (Crystal filter Termination) https://www.hfsignals.com/wp-content/uploads/2019/02/ubitx_v5.pdf

Okay, you can see the hole for the screw, after pulling up the raiduno it wil fit but i think cause of all the problems i had, som contacts will not connect with the motherboard

I do have a V5 board.? To be clear, I have not yet made any modifications to the transmit chain... the only thing I have done is adjust RV1 to increase the output power on 80M to about 12W.? Before

Oké iedereen, bedankt voor het beantwoorden. De C die ik op de microfoonlijn moet plaatsen, is misschien een oplossing? Maar voorlopig heb ik gisteren geprobeerd om de radio stap voor stap in elkaar

Well ...anything you've got is better than nothing ...back in the old days, folks used a wave-meter (gdo in diode position) to check for spurs/harmonics ..was hoping for some before/after

If you have a decent amp meter you can adjust RV2 and RV3. Don't try and set them by ear. Review. the procedure on line. All three RV adjusters adjust the final power out be it ditties or voice.? I

Hi Rob, Well, what is the power meter you are using?? If it's a 100-200W maximum meter, certainly it will not have much accuracy down below 10W. Do you have, or could you get, an oscilloscope?? That

The BFO settibg depend on the crystal filter that your board has. Thus each board is unique . You may not use ithers' bfo setting. Sarma vu3zmv wrote:

Jim, no, I don't really have a way to check for that.? I suppose I could use my SDR dongle as a poor man's spectrum analyzer??? See what other spikes I get in the spectrum when I transmit? I will

for a BFO frequency that works for my V.6 is 11.056.0

Rene Lets get a bfo setting value from another v6 or v5 owner. That would get you close. We can address transmit audio later. Let's keep the steps small, no bold changes yet. Curt wb8yyy

Here are a couple of tone clips that might be useful; 700-1900 is 2 tone? 300 and 3000 are voice BW max & min. I use another SDR spectrum display to check spectral purity for things like harmonics.

Just a random thought ...do you have any way to check for harmonics/spurs at these settinjgs? while tuning for "maximum smoke" is one way to do it, what you are measuring with the power meter is

There is other software, but none of them are going to solve your problems.? They change some of the operation, or add features that are not there now.? Nothing to solve the calibration, low

We have three power meters. None of them read the same. On one it reads 5 and the other 20 on some bands. Which is real? Have 4 ubitx and the best comparison is to compare between the units. The

Is there maybe a diffrent software i can put on the raduno?? or a total reset??

Now i have the radio dis manteled, and try to build it up again....but no hope for it, 250 euro in the trascan maybe???

Thanks, Curt.? I will be sure to look at my output in SSB before I go do any further surgery on my board... I also have some small fear of breaking something I can't fix when I go swapping out these

I have the speaker from the baofeng microphone removed and put a new electred in the microphone, every move i make seems to be worse......maybe gonna drive with my car over it. Pffffff if i reed al