开云体育

Set the BFO again. Use this https://www.hfsignals.com/index.php/bfo-tuning-aid/ (it works only with Chrome Browser, you might have to download it to your computer/phone) - f

Dennis, I found a number of them on Amazon.? You may do better on ebay. Search for a "baofeng radio mic" As Farhan stated above, you will need to cut off the 2 jack plug and wire in a TRS

I just got the v6 built but ran into this problem. The side bands are reversed on the uBitx v6 how can do I fix it? When changing bands the it will not change side bands a well. Hope some one can

I have had good luck with the following amplified mic: https://smile.amazon.com/s?k=Barjan+CB+Amplified+Loud+Power+Microphone+for+4+Pin+CB+Radios&ref=nb_sb_noss Of course a better choice would be to

We just snip off the original twonpin plug and solder a stereo jack in its place.

Does anyone have a source for the microphone supplied with the uBITX V6 full kit?? I would like to obtain a couple for some other projects.? I have searched the net and could not find a mike like

The problem for me is that the components are surface mount. This 82-year-old man with glasses, bad shakes, and a 300-watt soldering gun is not going to be replacing surface mount components.

To put it plainly mine sucks! Took the Baofeng mic apart and found a hole about 1/32 to MAYBE 1/16 for your voice to get through to the condenser. Will open the hole some and try again but don't

I dissambled the mic and it didn't have any obstacles to the encapsulation. To be sure I even tried to talk using the mic capsule directly and it didn't work fine... I will try to substitute mic

Thank you, the "ATmega 328 (old bootloader)" option did the trick! I swapped speakers but got no sound, swapped again and now it works great, screech is gone and plenty loud. apparently the little

Richard, I have used the BFO online tool (as well as a free audio spectrum analyzer program) for my v4 and v5 ubitx.? The only difference is the BFO frequency; the audio out and the width of the pass

Thank you Barry. That's what I like about this group. When anyone has a uBITX question, someone else usually has the answer. If no one has the answer, competent members work together to find it.

Bill I should have said that is for non-V6 units, now the V6 uBITX have included the resistors on the board. So with the V6 you may only need to set the menu selection to Keyer or paddles. I don’t

Mine isn't that fancy Wayne, I just did a cable swap

Thx for fast answering Regards Rene

I have had this problem with another bowfung (?sp) microphone. I wanted a speaker/mike for my handheld 2-meter radio. I purchased one and was told that the audio was very bad. I purchased a? Kenwood

5V is probably normal: half a 10Vsupply via a (typically 2k2) resistor.

Disassemble the mic, lift the capsule out of its molding and ensure the path to the front is not blocked by a film of plastic ('flashing'), a frequent artifact of the injection-molding process. The

My V6 at 13volts draws 400ma.

Ashhar, this video - and the BFO tool online - are really excellent. Question: I have a v5 to build. Couldn't I use the online BFO alignment tool with the v5 as well? There would seem to be