开云体育

I used this one: Nextion 2.8 inch Display... https://www.amazon.com/dp/B07Q36RBV2?ref=ppx_pop_mob_ap_share And then loaded the kd8cec code on it and updated the firmware on the v6 to the v5 CEC

also found this: https://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01008.html#s4.1 “Build” in the context of the Basic Certificate is limited to the assembly of commercially available transmitter

I tried to re adjust the two bias pots by following the ubitx guide. It says to first turn them clockwise and measure the current, when doing this my total current consumption in 1.2A (some searching

I wondered the same thing, but apparently the ubitx falls under the " With Basic Qualification only, transmitting equipment must be either a commercial pre-assembled product or a packaged kit

I was a volunteer examiner here in Canada for our rural locale and Basic Plus gives a successful candidate access to all bands including? HF bands below 30MHz with power limitations and using

Dayne, Mark could well be correct.? If RV2 and RV3 got twiddled with, that fully explains this. The fact that the problem does not move when you swap the IRF510's suggests the IRF510's might still be

Please do me 2 of these as well, very nice, thanks! -- PE3ES - F4VTQ - Erwin 73

Bonjour J'ai attendu quasiment 1mois. Il faut aussi compter une semaine entre le moment où vous payé et le moment où la commande part. Patience...

Bill, Looking Good! Now a question and a request. The question is which Nextion 2.8" display did you use?? The enhanced or basic? The request is if you could point me to the Nextion HMI or tft file

Hi Nick, Very interesting. Can you put my name on one, please ? Jean-F5PCX.

Only question that comes to mind is does the UBITx kits fit into "commercially built & certified"? category or "homebrewed" ?? because Basic-Plus requirement also requires gear be commercially built

Beste Nick, ik zie dat je heel veel vrienden hebt. Graag zou ik ook zo een board bij je willen bestellen. Groet Rene Nederland

HI Niels If you don't want to receive emails you will need to unsubscribe using the link on the bottom of the emails you get from the list. It is right down the bottom of the email. 73 Murray ZL2IQ

Dear group, please cancelled your email to willum@.... Niels Willumsen, oz4wil

Mark - I think he does. https://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01008.html#s4.1 says Dayne - FT8 (among many digital modes) runs the radio pretty hard, since it transmits for long periods of

Hi Dayne, CONGRATULATIONS Welcome to the amatuer radio club its the best in the world youll find people on here are very helpful..Regards Dave G0 AYD..

Hi Dayne, I would redo the bias setting in the finals. There should be instructions for that on ubitx.net or on the list here. Congrats on your new license! ?I ?wondering however if your current

Hi Thomas, I use vscode too, but currently use the "Arduino for visual studio code" plugin, rather than the PlatformIO plugin. However, new tooling on branches that have no relation to Mark's

Hi Mark, Can you create a new branch for your changes (as mentioned in /g/BITX20/message/74898 ) and then make a pull request to my master branch? I could just copy your code into it,

Sorry, Can i have one too 73 Fr4ta Daniel