开云体育

Si je peux en avoir une je serai heureux 73's Fr4ta Daniel

Jim, You mentioned leaving the A6 wire disconnected... With a V5 board, I just need to NOT connect A6 to the resistive divider and/or pullup resistor for the CW key the way I did previously, right??

Hi Thomas, You need to use Chrome or a Chrome-based browser.? Vivaldi browser works fine on my computer. 73, Mark.

Pin 1 - Ground Pin 2 - Microphone Pin 3 - PTT Wire the ground side of the microphone element (one with connector fingers touching metal case of element) and one side of the PTT switch to Pin 1. Other

Thomas, et al, "Spectroid" by Carl Reinke, or any audio spectrum display available for a smart-phone or tablet, works. While I applaud HF Signals for making a utility available for the purpose, it's

Do you have a microphone attached to the device you are using to access the web page?? It will not work without a mic, and it will not give you a reason, just a static page without the graphics. If

A simple variable voltage divider as on the v5 would bim the display. Thats how im settong my v5 with v6 screen

Evan - The tuning aid site appears to be not working. I gather it is some sort of audio analyzer. I will try to find substitute. TNX for help.

All good points around cost. It will be interesting to see how the programming of the TFT goes. Things that would be great is a way to lower the current draw on the TFT perhaps a way to dim the back

Thanks Evan Found it now

Thanks Wayne. I will be using the mic element and switch that came with the kit. I understand that you cannot comment on the actual pins to connect to, but can you confirm that my thought process is

While I cannot Tell you which pin to wire which wire to, it depends on the mike plug. I personally plan to use the 8 pin socket that a coupe of my radios use. And I have 2 mikes wired that way. One is

Please forgive my stupidity....I have searched and read and still cannot comprehend how to connect the provided mic to the 4 pin connector. I am really confused about the 3 pins and only 2 connections

I don't think there is Andy but it is really east to make one up on a piece of vero board. ( test points in parallel with (tft/nano board)

going for external 3.3v regulator and external level shifter as suggested by G8DJM

Is there a mfr's extender board available that can plug into the nano/TFT board combination socket to extend display and nano combo board above the chassis box to be able to use scope probes and/or

Thanks again David, I ordered some too (plus some 8 channel). Saves time soldering lol. Brilliant circuit. 73 Brian_____MM0BEF

Hi Evan, Where is the screen that shows the current settings?

I agree Reed, The nextion in bulk would be substansually more expensive than the one supplied with the V6. People will mod it close to the cec firmware though , even though it has not the memory or

I haven't played around with the Nextion for years, but I felt constrained by the programming environment. I'm sure cost is a very important factor, too. Jack, W8TEE