开云体育

While I cannot Tell you which pin to wire which wire to, it depends on the mike plug. I personally plan to use the 8 pin socket that a coupe of my radios use. And I have 2 mikes wired that way. One is

Please forgive my stupidity....I have searched and read and still cannot comprehend how to connect the provided mic to the 4 pin connector. I am really confused about the 3 pins and only 2 connections

I don't think there is Andy but it is really east to make one up on a piece of vero board. ( test points in parallel with (tft/nano board)

going for external 3.3v regulator and external level shifter as suggested by G8DJM

Is there a mfr's extender board available that can plug into the nano/TFT board combination socket to extend display and nano combo board above the chassis box to be able to use scope probes and/or

Thanks again David, I ordered some too (plus some 8 channel). Saves time soldering lol. Brilliant circuit. 73 Brian_____MM0BEF

Hi Evan, Where is the screen that shows the current settings?

I agree Reed, The nextion in bulk would be substansually more expensive than the one supplied with the V6. People will mod it close to the cec firmware though , even though it has not the memory or

I haven't played around with the Nextion for years, but I felt constrained by the programming environment. I'm sure cost is a very important factor, too. Jack, W8TEE

Hi Bob, ive found the same on my V6 and am very pleased with it now ive eventually got into the settings to change it from straight to paddle key .now on the hunt for a nice add on cheapishadjustable

I don't have a good answer for why he didn't base the v6 software on the CEC version, but the screen choice is absolutely cost driven. Nextion screens, while not all that expensive, are MUCH more

me too and thanks for the help

In my case, using a dual paddle, it takes about a second for the initial dit or dah. After that operation os OK as long as you maintain your rhythm. If your pause is too long, the next dit or dah is

Evan, please study thevpost PA lpf for 40m band. Let us take sch values as correct. Tro take out the coils one by one ( you can do without removing the board) and check for inductance and do some

One more note. In the CEC setup on the display you and lower the brightness of the display to further lower the current draw. Doing this I’m now down to just 200ma. Also you can set a timer o turn

The short answer is yes.? However it is the same basic process as the v4 2 line display.? On the Home screen, when you press the encoder button, you get a yellow 20x2 text box come up that has the

Hi can you calibrated from nextion screen

Thanks, I just ordered two sets (10) from the ebay US site for $2.66. Doesn't make sense to roll your own. Dale -- Dale Hardin Elberta, AL

Hi, I have an unbuilt complete version 4 for sale.Mini stroke stops me starting this.?75.00 plus post. Contact me off group daveg0ayd@... willing post anywhere as long as you pay the postage

Hi Gary Yes sorry the regulator backwards, my bad eye's and late at night I missed that, all fixed and the new version uploaded. Why use an additional regulator.? It's the backlight that draws most