开云体育

I think I see a problem...perhaps not THE problem, but a problem. EVERYONE: ??? Whatever is the project's INO primary file name (e.g., ubitx_v6.3_code.ino),??? which is the file that contains

I don't understand. What is the Raspberry Pi for?? Also, what is "Arduino 2.1.0.5+dfsg2-4.1". If you are compiling on a Mac, what is the emulator program? Jack, W8TEE

Bob, That log also shows a successful compile, but unsuccessful upload to the nano. Try changing the serial port the IDE is using. Reed

here's the errors on the mac using v 1.8.10 -- Bob NZ2Z

Bob, I don't see a complier error for you either. However, yours does show a failure to upload the program to the nano: Is there another serial port you can try? Reed

Hello, BITX was release initially for experiment and education and currently you can find find a lot of information which are common to all BITX and currently provide a huge amount of information.

Ted, Thanks for that. Lots of experimental fiddly tuning with that, but with some effort, maybe will pay off. I notice that it didn't appear that he was able to get any useful WSPR results on 20M and

Here is the compile from the Mac -- Bob NZ2Z

Jack, Raspberry Pi 4 Arduino 2.1.0.5+dfsg2-4.1 All of the files are in /home/pi/ubitx6 (these are what I downloaded from Farhan on github) Attached is the file from this attempt I will send the

Thanks Jack, it uploads using the old bootloader the ch340 driver is installed.. Yes Reed, Its connection issue. I will need to increase the resistor values on the lines. Just me being stupid and

Yep. That's why I think it's a connection issue of some kind. Brian, did you make sure that the panel you got uses the same ILI9341 chip for driving the screen? Is your screen's reset line pulled

If it compiles but doesn't upload using the Old Bootloader, did you install the CH340 driver? If not, search for "CH340 Device Driver Download" and install the driver. Jack, W8TEE

I don't see any errors...only warnings. Jack, W8TEE

have been flashing nano seperately each time still no joy MM0BEF_____Brian

Its driving me nuts. Connections all ok and wired as should be. still nothing on screen. Flashing v5 code back in till i can think of something else. MM0BEF_____Brian

You might also try removing the nano from the radio entirely, then upload. If that programs successfully, but doesn't seem to work in the system, you'll probably want to start buzzing out connections.

still doesnt work, uploaded Reeds pre-compiled hex and that just gives white screen too. May be to high a voltage to data lines ill run the pins through a 1k resistor to see if that helps.

These are the warnings\errors i get with Reeds pdq code. just about to upload and try it. MM0BEF_____Brian

thanks

Hi, Just uploaded and still white screen. Ill try compile Reed's code and try that. MM0BEF_____Brian