开云体育

Jack, Raspberry Pi 4 Arduino 2.1.0.5+dfsg2-4.1 All of the files are in /home/pi/ubitx6 (these are what I downloaded from Farhan on github) Attached is the file from this attempt I will send the

Thanks Jack, it uploads using the old bootloader the ch340 driver is installed.. Yes Reed, Its connection issue. I will need to increase the resistor values on the lines. Just me being stupid and

Yep. That's why I think it's a connection issue of some kind. Brian, did you make sure that the panel you got uses the same ILI9341 chip for driving the screen? Is your screen's reset line pulled

If it compiles but doesn't upload using the Old Bootloader, did you install the CH340 driver? If not, search for "CH340 Device Driver Download" and install the driver. Jack, W8TEE

I don't see any errors...only warnings. Jack, W8TEE

have been flashing nano seperately each time still no joy MM0BEF_____Brian

Its driving me nuts. Connections all ok and wired as should be. still nothing on screen. Flashing v5 code back in till i can think of something else. MM0BEF_____Brian

You might also try removing the nano from the radio entirely, then upload. If that programs successfully, but doesn't seem to work in the system, you'll probably want to start buzzing out connections.

still doesnt work, uploaded Reeds pre-compiled hex and that just gives white screen too. May be to high a voltage to data lines ill run the pins through a 1k resistor to see if that helps.

These are the warnings\errors i get with Reeds pdq code. just about to upload and try it. MM0BEF_____Brian

thanks

Hi, Just uploaded and still white screen. Ill try compile Reed's code and try that. MM0BEF_____Brian

Thanks Joel. I already have the old bootloader selected. Thanks Reed. I was getting errors as well as warnings but i uninstalled the ide and deleted all directories and folders relating to it and

Well, there is this........? an end-fed multibrand using a trap. http://www.infotechcomms.net/downloads/Multi_band_EFHW.pdf

Brian, It looks like those are warnings, not errors. There are binary starts at the end of that output. Are you unable to upload that code to the nano? Reed

Hi Brian, Change your processor type to 'Old boot loader' that should let it compile. Joel N6ALT

hi, im getting compile errors on stock V6 code. Im using win10 and arduino ide 1.8.10 . Its set for the nano and old bootloader as this uploads to the origional nano. compile Errors.txt file is

All it involves is using a photo quality paper and using a drawing program to create a "faceplate" and then print it on an inkjet printer. Al uses an Xacto knife to trim the TFT display opening. The

jack. how are you doing the labels on your projects? dave k7da

Glad to hear it’s working! Just a follow up question: Is there any additional hardware required besides a laptop running WSJTX to operate with FT8?