开云体育

@MadRadioModder, I mean, sure, if you buy a faster processor you'll get better performance. That's not really the point, though. My branch gets reasonable screen refresh speeds at zero additional cost

Yeah upgrade to a Teensy 4.0 with W0EB’s daughter board and watch how fast it goes… The display will be the rate limiting step. Sent: Tuesday, January 7, 2020 3:38 PM To: [email protected] Subject:

Philip, Did you update to the pdq_gfx_update branch, or something else? Reed

Replace Q13...It has most likely shorted internally...It is the predriver to the transmitter stage...

Yes it does now I have updated it

Interesting reaction.? I watched Ashar's video introducing v6 and it seemed fast enough to change bands etc.? usually its the tuning knob and volume control that get all the action.? I didn't see a

Full kIt arrived the day before New Years. Reflecting on packing it was OK...nothing was scratched, dented or flopping around for the DHL shipment time of 9 days. Assembled last Saturday.? Played

No pre-compiled binary, but I do have a branch (and outstanding pull request) for a much faster version:

does yours allow selection of 17 m band? if not maybe a newer faster one might have that fix in it as well

Just built my uBitx v6, I cannot believe how slow the display is. Could someone post a compiled HEX of the faster firmware. Philip G7JUR

Mine turned up with damage. The volume pot broken off the the board, marks on the touch screen, and damage to the corners of the case. Also chipped paint work. Philip G7JUR

And I, for one, do not want the group to fracture into subgroups at all. I find all emails about the uBitx and Bitx40 relevant, not only to their respective radios but across versions. I do not want

Hi Andy, 12V @ 6A?is good, but doesn't actually indicate how "fast" your power supply is. Power supplies have ramp up times and response times that determine how "fast" they are. I agree that not

V 1.27 no mods, except fuse at 12v input.? Checked R133 and R134 and both show open.

Hello folks, Attached is draft Noobie guide pdf version for comments/improvements. If my bricked rig solution is repairable using software re-install I will add that procedure to end as well. I'd like

No need to apologise for a lack of knowledge Andy. I think this group was designed to gain knowledge. Keep on with your vision. 73s Ken T VK2HXX

I have a dedicated 12 VDC @ 6 Amps supply for the uBITx transceiver with no other load on it.? The only thing I noticed in past sessions after connecting to laptop via USB port was that if I shut off

The white screen at power on is something I saw in my development too: /g/BITX20/topic/ubitxv6_bricked/69359467?p=,,,20,0,0,0::recentpostdate%2Fsticky,,,20,2,40,69359467 Seems like

First of all, let me clarify something here to eliminate confusion.? The TSW Teensy 4.0 to NANO adapter I mentioned to start this thread has NOTHING to do with the RobotDyn SAMD21 board some of you

I recently saw a couple of posts that mentioned a 4 port USB expander/extender was used with UBITx xcvr. I am interested in the details of how it was installed to be used. The one expander I have