开云体育

I'm actually working on the PCB to add the AGC mod and also a Smeter for my uBitx. I've choosen the VK2ETA AGC mod and the KD8CEC Smeter. Here is my schematic made with Kicad and the board which will

Hi all, whats your thoughts, while using wsjt-x for ft8 I have been noticing a peroid of not receive data on the water fall, until I click the tune button on and off. Then all works as it should.

No.. gonna try moving the radio.. it is a bit high noise in the spot it is in.. on my 450d it would be s5-s7

It sounds like an internal spur. Do you have the same thing on any other radios in that room? -a

I should add its there through all volumes, and is same with or without nextion firmware. relative to the earphones its not loud but noticable... Am I over thinking?

Ashhar: Thank you for designing the Antuino for us! Chris Shaker

Chris, here is the Antuino group forum on : /g/Antuino/ Garry

Another point of view is to stay with the standard LCD as it works decently. The color displays add appreciable power consumption. Someone with motor skill issues may do better with the standard unit,

The Antuino draws 0.080ma at 5v. With a linear regulator to 5v, the regulator is dissipating (12v-5v)*0.080 = 0.560 Watts. Much over 12v going in and the LM78L05 will soon overheat and go into thermal

Hi everyone, I am experiencing something odd, when tuning around on dummy load or no antenna/dummy load attached i hear a high pitched squeal that goes up in frequency as you tune a couple khz up

Thom Yes, it can be a a bit overwhelming the options for the build. We are adding the JackAl board and 7" screens. I also have a Bitx40 that I was planing to build as portable unit. Since new Ham's

https://n2htt.radio/2019/05/26/hello-antuino/ This gent says 9-12VDC, but the voltage regulator data sheet says it will take up to 30VDC.? Take note of the milliAmp rating.? It is low, so I'd stay

Adrien -- I did exactly this with a old 16v laptop brick power adapter. The 16v from the power adapter went direct (well, thru a fuse) to the brown wire, and direct to a? DC-DC down converter making

A 12v power supply is recommended. It draws about 80 ma of current when in operation. Most of it goes to light up the display. I didn't have any spare pin on the Arduino to turn the power to the

Raj: Thank you. I did actually resolder both sides, and used a solder sucker to remove the excess. I'll look at it again tommorow. It powered up and worked with a 12 vdc power supply. Chris Shaker

I am looking forward to receiving my Antuino :) I guess I would power it with rechargeable Eneloop AA batteries. I think that keeping the voltage at 8 or 9vdc would keep it without overheating if used

Chris, The power connecter leads have to be resoldered on BOTH sides of the PCB. The reason is that PTH has been drilled out wile fitting the socket. Raj

Damn. Guess I could have done that, too. Thank you! Chris

Just replace the Nano and see. While desoldering leave the pins on the Raduino board and remember to order a Nano without soldered pins. Use some help if you are not confident! Raj

Yer 9 volts 500ma should handle its operations just fine. Ed N7SNT