开云体育

Stand alone just like you see in the picture. Uses the Audio Adapter/ Shield board from prjc.com, a Teensy 3.6, a small SPI 7735 display, two encoders, and two LEDs. That’s it. Custom code. Not

Success.? The problem turned out to be a short between the mic audio line and ground.? Sunil from amateurradiokits.in had sent me a second front panel PCB after I reported my initial problem to him.

Curt -- I can reflow each pin if I pull up my pants and stop being a whousssssss. Good implyed question on the drive level. SWR meter says 28w on wspr on 80m, which means two full minutes of hard

I've been reading the topics regarding the ssm2167 with much interest.? So finally I integrated the board into my ubitx v5. I ended up with a trimmer on the output of the board, and pots on the

The sofa beams Audio DPS boards...there are several models...are stand alone boards, no coach needed. Simply insert in your audio chain and add power. It works great. Far better than I had hoped. They

The 12/11mhz crystal filter is after all IF amps on receive. The IF amps are operating at very low signal levels, most of the gain is in the audio amps. It's the audio pre-amp (a 2n3904 just before

Don First before we assume its a bad relay, reflow each pin and also reduce the transmit drive level. You never know the relay may be okay. I assume you tried more than one band? Make sure you don't

The JackAl board looks like it is a good all in one upgrade to the uBitx. So it looks like, in all but the more extreme cases, people are happy with DSP audio bandpass filters. Crystal CW filters can

That looks like a cool implementation. Is your audio bandpass filter stand alone or is it an add-on to the Sotabeams filter board? It sounds like it is a stand alone DSP filter and display. Is the

You are welcome! Just learning myself. Best regards, 73, Jim

See note on their link https://amateurradiokits.in/product/raduino-clone/ [image: image.png]

I know but I couldn't find the original Raduino on HFsignals

hello all! My beloved V4 uBITX has been working really hard and flawlessly 24/7 in wspr mode for (almost) months at a time. ?The results are impressive...frequently in the top 10 worldwide 2 way spot

Thanks Jim! Where were you three weeks ago?? :) My experience exactly. Your straightforward post will really assist new builders, Dean KK4DAS

Ken, that is the Raduino clone by Sunil.

If you're looking for a cheap VNA this might be of interest. /g/antennas/topic/nanovna_cheap_vna_on/31731387 I don't consider this to be competition at all for the Antuino. --

Jerry, Thank-you for the clarification. I was aware that you can measure SWR with just the scaler values, as I have built a resistor bridge based scanning SWR antenna analyzer, and purchased a cheap

Evan, Looking at the Antuino schematic, it has an AD8307 at the output of the 25mhz filter to tell the processor the magnitude of the received signal. Nothing to tell the processor anything about

I use a simple sofa beams filter in my audio chain. It works fantastic. Check it out at

I am traveling on business, so can not get at the documentation on the CEC software.? From memory I am sure that one of the control shifts the signal on the "roofing" 45 mhz filter to act as a gain