开云体育

Are you using electret mic as the mic pin is having dc bias voltage? Generally we provide a 1nF cap across the electret. That filters rf induced on the mic cable. Reg ver 3 drawing 650mA on Rx with

Why overdrive? I have not overdrive when clockwise the rv2 and rv3 is 450mA and i give 200mA with anticlockwise screwing to this, and so 100mA at each PA how it was sayed i? HF Signals, but i have

Overdriving the mixer/modulator is not a good idea because it can cause higher level of spurious output. _._

Take this topic some were else. If you are so hard up, you do not need a hobby. Sell all your radio gear and support your family. Been there done that. K6KWQ Dick Sent from

I have V3 and i have an idea to rise up the output with an mic amplifier but i want look for an simple homebrew mic amp, but i think the problem is the voltage on mic cable for the amp, i read here in

(Yeah, another book...) Add to that the fact that insurance companies generally charge poor people extra for insurance (at least, in this hellhole of a state), and if the vehicle is lost, will only

Insurance on older vehicles costs more than the vehicle is worth, and usually has a high deductible. The truck is a 1983 Had it since 2004.

The attached April?Collins Amateur Radio Club Newsletter has a very comprehensive BITX article by?Vince Loschiavo N2AIE which he has posted to the FB group. Though it worthwhile to post here, hope

The attached April?Collins Amateur Radio Club Newsletter has a very comprehensive BITX article by?Vince Loschiavo N2AIE which he has posted to the FB group. Though it worthwhile to post here, hope

Did not take insurance ? I take the maximum possible for all my vehicles.

Forgot to add, I have a gofundme set up to try and get enough for another truck. Have $725.00 in it so far, and a couple of checks also, one for $500. from a relative, who is NOT rich, but evidently

The only other things that are salvagable are a gas container with a bit of gas, wonder it didn't catch, plus a gallon of mixed antifreeze. Will remove the Reese hitch, and hopefully the belly bar.

Hi John, no problem - there is no excuse needed. And thanks already in advance. You are not obliged top help at all ? :-) Sascha

Good. I need one provided it can use with uBITX MULTIBAND Version 5, 2018 KIT . De VU2UYC Balsun. Email me bsnvu2yc73s@... 73s [email protected]> wrote:

kj5w Frank. A well spent $10 insurance policy for electric & electronic as well as anyone doing walk in repair or

(Laugh) I know what you mean.? Most of my customers didn't care, as long as they couldn't be held liable or would have to pay out of pocket.? I was just a service provider, not an employee so I

I worked for a company that didn't care much for lock out tag out procedures until one guy almost got killed. Management changed their attitude pretty quick then. Robert

That actually has a much more appropriate response curve! I feel like the issue now is more related to signal density then anything else. As in with that 10Ω Resistor we are finally getting an

I didn't have a lock... and the company didn't provide one - considered a tag to be sufficient.? That was back in the late 80s, as I remember.? Tagging and locking were considered "Government

That is why you lock out and not just tag it. Robert Alexander From my iPhone 8