开云体育

Hi Ted. I briefly saw your screen layout and understand Sams questions. Yes your S meter is slightly off. It runs over the white lines that which are part of the image. Also the frequency dot Sam is

Mark, it is a DP3T on/on/on often referred to as a shorting switch. ?Jack, the schem we use is the same as nd6t's with the addition of a 5v reg and not as many decay setting options that's it. Once

NOW SOLD

Thanks Vic, did not know there was an option.Randy

Hi Ted, Yes...s-meter, etc. Funny...just did this last night. I wanted the freq display more to the left and down a bit. If the decimal is painted, I have to move the freq controls and then figure

Hi, Sam. Please explain what you mean by painted items.... do you mean things like the S-meter path that gets overlaid with the moving meter graphic during operation?? What does controlling a

Thanks, Tom -- that's what I'm seeing. Through the transverter, with an old HP 8660 synthesizer providing -140 dBm, I am just barely able to hear the synthesizer (so I think noise figure is OK),

I wish I could go, but have several reasons why I cannot. The biggest Hamfest I have gone to is the Rochester NY one.

Fan blows on finals. That wiring lasted all of 5 minutes. I have it switched to the rear. I did add a resistor in series and cap to ground to get rid of the noise

Hello Sam, It would appear from your photo of the wiring that your fan is wired to suck air out of the case, rather than blow air on to the heat sinks.? Is this correct? Thanks and 73 Kevin VK3DAP /

Randy Vic likely has it solved, I forgot about that setting to change from paddle to key. Curt

If you have selected one of the keyer modes (Iambic A or B) then the straight key will have no effect. Select straight key and all should be well. =Vic=

Sorry Adrian, used wrong address.

Will buy if available, Payment by PayPal Friends and Family, if thats ok let me know total cost inc postage to CV10 9JQBrian Arnott (G3YYT)?

Roger , maybe interested Adrian -- Adrian Blake, VK2ALF 101 Mulach St Cooma, NSW, 2630 Australia Mobile +61 407232978 P?rna tn 3 Otep?? Valga Estonia Mobile +372 51971441

Complete v5 kit i part built up to the point it works with no errors but gone another route on a QRP rig so not now needed. A couple of months old. ?75 plus carriage to wherever you are. PM me if

I think I'll need to find some shielded inductors for this filter as recommended by Raj. I used the ones I mentioned previously. I also noticed that I had the function

Hi, That's not a 2P3T switch.? With only six connections it can either be a 2P2T or a 3PST. 73, Mark

Hi, Is it possible that when the uBitx is receiving through the transverter the noise level will be greatly increased.? At VHF and higher most of the noise comes from the RF preamp stage (rather

I saw but!