开云体育

Probably the same case we used: It's all metal except for the "edging" which is plastic. Jack, W8TEE

Thanks Keith

?

Thanks Lee

Looking for ft8 digital mode tutorials to connect uBITX V4 to Notebook via USB cable. How do I connect uBITX V4 to my computer? - -.- . '.73 Rubens PY2PVB. '. Ilha Solteira - SP - Brasil

I have the exact same case and it is four panels ie top bottom and two ends, front and back panel all metal and the plastic surround back and front. You ideally need an m5.5mm nut driver to dismantle

Made a case from the recipe..? like a gingerbread house only squishy...? ? It looks like the blue is metal and the white is is plastic IMHO One review states the dimensions are off? Check that

I have a similar case and the only plastic is the white parts. -- Lee - N9LO?"I Void Warranties"

Sorry about it folks Probably the copy and paste didn't work and the previous link was posted instead. Here is the correct link and I checked

Correction, the 6600 does go down to 1mV steps. The 6800 goes down to 0.1mV steps. 6800 is a bit flakey to operate.

Hello Cristi ! uBitx manager does not work with original firmware.It works only with CEC firmware. Please read article about how to make work the manager with original Fahran's firmware on Ian's site

Lesson learned the hard way. Attach the heatsink to the LA4225 chip before soldering the chip to the PC board.? Otherwise, inserting the chip down as far as it will go and soldering will result in

MadRadioModder presents a universal—no messing around inside—safer for all solution. Both work but his leaves any equipment unmodified.

True, searching for "6800 generator" should do the trick! I think the difference between 6600 and 6800 is minimum 10mV steps or 1mv steps. Not sure but need to check. Raj

Hi Matt, Pl note i chkd in the editor app that ubitx_35E6.hmi (which was originally written for 3.5" 320x480 res.) didnt hav the 13th& 14th pages- pdsp & pcw mean for dsp & cw setup. Whereas the

Have you by any chance set the S-meter values in the memory manager utility? If I remember correctly the defaults are set to zero. Skip Davis, NC9O

Hi when you say modified what do you mean - what steps did you take? when I was resizing - it was important to note that the image files need to be the coirrect size resolution for the display see

Hi, Here is an explanation of the transmission line defying properties of high frequency scope probes. https://www.youtube.com/watch?v=OiAmER1OJh4 Here is one that doesn't defy transmission line

thanks, Tim!!? yes using the kit-projects AGC.? tried the direct connection but it did not work. using the correct version of the ubitx firmware, and the 2.4 tft for the nextion.? not sure why it

Sorry, Tim, I do have another V5 but it is still in the box it was shipped in. Just to be clear here are some notes on how I? tested: * signal generator is a Sark 110 using an unmodulated carrier,