开云体育

Well I used the 7” file and selected my screen size and compiled. It looks like it’s all in place not like going from a 3.2” file and loading on a bigger screen. Lol. Anyway I’m about to

Hi Joe, Is there a 5" version available? I just received my 5" Nextion HMI finally. I am trying a 5" tft file I found now but I am not sure if its the same as yours here.

Bill, Zero 'beat' is a bit of a misnomer as it's really a matter of listening for nothing rather than listening for something. To understand, let's review the similarities between hearing SSB and

Glad to hear that you found the problem.? I would also suggest the KD8CEC Memory Manager program.? That allows you to easily change any of the parameters including the memory presets and calibration

Thank you the hex file was the culprit I installed UBITXV5_CEC_V1.200_NX.HEX and it works like a charm.

Hi Frank, Interesting, how do you update the Nextion via serial. What do you have to do to the Nextion when sending serial streams. Thanks Laurence

tnx again ted, yes every day new challenges comes up in our wonderfull hobby ;-) And it is so great that so much OM work together worldwide to find solutions for this challenges and help each

Ted, Thank you for the reply. This is how I have been tuning (steps 1-5) and I did have it pretty good at first but I didn't realize you had to cycle off to set it. The first night I heard someone

You're quite welcomed, Frank. I've learned a few things by trying, while the next step will be to begin from scratch or close to it.? If this has helped one guy or just a few, it was worth it.?

Ah, ok, mni tnx for your help! I found a solution from Ted #67572 ( /g/BITX20/message/67572 ) and it looks pretty good for me - mni tnx for your work Ted! I think I should

Ted, thanks for posting that bfo calabration. Looks very similar to the old R388 instructions used by myself back in the early '70's. Somewhat tedious but always checked out against primary standards

As Ashhar stated above, be sure that you have the correct program for the Nano. The correct version for v5 uBitx is in the "uBITXV5_CEC_V1.122.zip" zip file.? For my v4 boards I used the

Which version of the board do you have? I hope the IF is proper. IF of V5 is about 11.0555 Mhz and lower versions have 11.997 Mhz or thereabouts. - f wrote:

Well the hot regulator is easy. I discovered it when my rig was having issues, and was spooked. It is normal and okay. Did you have signal before you installed the nextion? Usually folk build the

Thank you to all that helped with prior problems. I have the nextion 3.5 working fine.? I do not know what I did BUT now I have no receive. When tuning I hear faint notching with dial turn matching

I've encountered several recent clone?V3.0?Nano's with old bootloader pre-installed.? As Jack said, you can overcome it in the newer IDE. If you have a USBasp programmer, you can easily flash the

Frank, those files only properly fill the screens up to a 2.8". Anything over that size?was given as a "go forth and figure it out" and needs to be resized. Check the "Files" tab to the left and see

The circuits are freely available at hamradiodesigns.com Jack, W8TEE

I don't know the software that well, but is there a version that is scaled to the larger screen size? Given that the Nextion display reads the graphics from an SD card, it may be a static display.

A marginal ATMega382P swept up off some factory floor might? have IO cells that are more sensitive to RF than a good chip.?? I suppose. Such a chip is likely to have some other failure modes that