开云体育

Different front panels are available for order to swap out. I ordered my case with both the standard front panel as well as one for the Nextion 2.8" display. That way I could save shipping later for

Mike, Bill, it was as simple as adjusting the brightness pot for the display -- once I knew there was one.? It was set to maximum.? Rig is alive, hearing good, giving it a receive workout before

Jerry: ...I suggest you ignore all that C++ stuff... Such a blanket statement is really not good advice, as it depends upon the way the topic is presented. My chapter on the intro to OOP/C++ is

They do look nice. I have two and they better than average quality. The only down side would be modifying one for a different display. Too bad they can't figure out how to semi punch (on the back

Ted K3RTA I would second Jack's suggestion. Read *Beginning C for Arduino*. It is great. There are also other *Arduino C-language* tutorials that are available with just a Google search. Starting

Thanks for the feedback and photos - I agree it looks like a great value. Now to pick a color... Ken, N2VIP

Ted, As a starting point, the code below should come close to doing what you want. It has not been debugged. And you will have to figure out how to implement? ?"tune_button_is_pressed" Good to

I know of a pretty good book if you're interested!! Some research: Read the Amazon reviews on Beginning C for Arduino to see if it appears that the book meets your needs. Make sure you look at the

Mine came with the SO239 socket for the rear of the unit. Instructions are mostly available on line but its intuitive. No clear written instructions that I could find at the time. I went by

I'd like some feedback on the case kits for uBitx from amateurradiokits.in. They look nice, and appear to come with the USB/DB9 board, a bunch of parts, and when combined with a standard uBitx board

Hello, Any news in the new version of antuino? I have all parts and want for the improvements! Regards Rick LU9DA

Thanks Vic. I did more or less the same (I didn't have a preset, so I soldered a 47 Ohm resistor) and it fixed the distortion as well. Ramakrishnan

Did both and problem solved. Had a couple 10k left over from another project and used one. The original pot looks good on a meter but didn't play nice. 1k resistor on center of control as well. Works

Some of these outfits are fast shipping. I ordered some of the relays from Arrow yesterday with free shipping and they showed up this morning via FedX Priority! ... and the prices were cheapest of the

Did you try adjusting contrast pot for LCD.? Also make sure the 5 Volts is at 5 V, should be within +- about .05V.? If still a problem, take the Raduino out and connect it to the USB on your

James, Thanks. I really just need to try to learn.? After having tried to work with stepper motors and multiple PID sketches unsuccessfully, Arduino programming has left a bad taste in my mouth. I

Call sign at Yahoo is best. Tnx, Ted?k3rta

Ted - It should be very easy to do. I don't have a Nextion screen with me, but I can help you with modifications. Will message offline. Ramakrishnan VU3RDD -- Ramakrishnan

No, the end purpose may be a curiosity though it ins't a primary question so far as programming is concerned. Maybe I want faceplate work lights to go on and then off, maybe I want to switch antennas;

Aha!? There is an adjustment pot ... Lots to learn here, thanks for the tip.