开云体育

Thanks Bill! ? I adjusted mine to 11.055.3 and The carrier is greatly diminished! Thanks for all who responded 73's Mike WA3O

Hello. Don’t forgot all. I’m looking for a uBitx full mounted because I’m not good with DIY..... Anyone more selling, in EU prefered? 73's de Carlos CT1GFQ SKCC#466T www.skccgroup.com REP#1406

ALL pre-orders have shipped wooh!. Tracking can? be found via your paypal transaction, if for any reason can not get to it let us know and we will forward the info to you. We should have more up on

I don't actually do CW -- so I'm playing conceptual catchup.? If the uBITX screen shows -780hz relative to the external receiver received freq, and if this is typical, normal, and std,then I'm happy.

I should add that I have not calibrated the V5 at all and that is using stock firmware, not Ian's beta v5. I was focusing only on the spurs and so far from an FCC point of view at first looks it looks

Thank-you Peter,I look forward to hearing from you. 73. Ian M0IDR Get Outlook for Android<https://aka.ms/ghei36> ________________________________ Sent: Wednesday, March 6, 2019 7:10:22 PM To:

I guess I should have stated this but the carrier is zero beat on my SSB signal. So there is no tone on my transmit that I know of. Thanks Mike WA3O

The carrier suppression is related to the BFO adjustment.? There is just one filter section for SSB that does double duty for both transmit and receive.? There is also only one BFO that provides the

Some seem to replace the older ubitx boards with ver 5. I too am thinking about that. But then what to do with the older boards? One idea that comes to mind is to use the ubitx up to the PA and drive

OK Ian, you were first in the queue. I'll email you direct with details etc. Peter.

Hi Michael. Please share your test results when you can. I have this issue on 20m only in cw on the v4, where I have close harmonic spurs about 10b down only. I already mentioned it on list The rest

I beg to differ! Sir, if the carrier is only down by 20dB then its not a question of looking at regulations! It is a strong indication of 'something being rotten in the state of Denmark' Translated

How much do you want for all that stuff?

Adjusting the BFO did the trick. For my v5 the BFO is set at 11.055.3

I too had this problem and yes it’s all in the BFO adjustment. I was able to get mine down.

Normally in brand rigs the carrier is down around 40db, in your case seems barely 20db. The question is if there is a legal limit to this. If this is legal anyway and sounds good in both TX and RX

I am almost finished with my uBitx version 4. It has the following: Nextion 2.8 SDR receiver/panadapter (switch selectable with input grounding relay when transmitting.) Built in antenna switch for

I should also note that I have turned the power down on the Ubitx to make sure I am not driving the amp with more than .5 watts... Thanks Mike WA3O

Group, ?I noticed that my New version 5 has poor carrier suppression. I noticed this when I ran my UbitX into my LDMOS amp and I seen about 10 watts out of carrier. I was wondering if it is due to a

Hi Peter, Further to my earlier e-mail requesting pictures I can see there is a lot of interest in the uBitX, perhaps you could kindly advise your payment details. Kind Regards M0IDR Sent from